answersLogoWhite

0


Best Answer

If you look a the wiper where it is attached, you will see a little sort of spring clip, when you push on this clip with a small screwdriver, it will release. There are many different types, so if this one is yours, it is very easy. The new one will just lock in when you push on it.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a Mercury Topaz windshield wiper?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Where is the windshield wiper control module located on a 1993 Pontiac Transport?

The 1993 Pontiac Transport windshield wiper control module is located on the firewall in the engine compartment. The windshield wiper control module will be on the passenger side of the firewall.


Can you locate the front wiper fuse in a 1999 ford expedition?

You can find your 1999 Ford Expedition front windshield wiper fuse in the fuse box. The windshield wiper fuse will be in the second column, fourth from the top.


Where is the wiper relay on a 1998 ford Crown Victoria?

The 1998 Ford Crown Victoria windshield wiper relay switch can be found on the firewall in the engine compartment. The windshield wiper relay switch will be on the passenger side of the firewall.


How to replace a 1999 f-150 windshield motor?

Windshield Wiper Motor Removal & Installation Front 1. Turn the ignition switch to the ON position. Turn the ignition switch ON until the wiper blades are straight up, then turn the ignition switch OFF. 2. Disconnect the negative battery cable. 3. Remove the right-hand and left-hand windshield wiper arm and blade assemblies. 4. Remove the cowl top vent panels. 5. Detach the electrical hardness connector at the windshield wiper motor assembly. 6. Remove 3 wiper motor (module assembly) retaining bolts and remove the module assembly from the vehicle. 7. Remove the wiper linkage retaining bolt and remove the linkage from the wiper motor. 8. Remove 3 retaining nuts and remove the windshield wiper motor. To install; 9. Place the windshield wiper motor in position and install 3 retaining nuts. Tighten to 10-12 ft. lbs. (12-17 Nm). 10. Connect the wiper linkage to the windshield wiper motor and install the retaining bolt. Tighten the bolts to 14 ft. lbs. (20 Nm). 11. Place the wiper motor (module assembly) in position and install 3 retaining bolts. Tighten the bolts to 6 ft. lbs. (9Nm). 12. Install the electrical hardness connector to the windshield wiper motor. 13. Connect the negative battery cable. 14. Allow the windshield wiper motor to cycle several times while checking for proper wiper motor operation. 15. Turn the windshield wiper motor to the OFFposition to park the wiper motor in the park position. 16. Install the cowl top vent panels. 17. Install the wiper arm and blade assemblies. Install the retaining nuts and tighten to 22-29 ft. lbs. (30-40 Nm). 18. Connect the negative battery cable. 19. Check the windshield wiper motor for proper operation and the wiper arms for adjustment.


Why do the windshield wipers on a 1993 Mercury Grand Marquis LS stop in up position when shut off but work fine otherwise?

the windsheild wiper motor clutch/windlatch is broken

Related questions