remove ..wheel...now tap out clip holding the caliper....remove the caliper and brake pads....... (hang it on a bent cloths hanger.............remove the bearing cover...........remove the cotter pin.......remove bearing nut.........pull off the rotor and wheel bearing..........remove bearings from the rotor and clean very good with solvent and repack the bearings with wheel bearing grease to be ready to install in turned rotor or new rotor.....now replace rotor and tighten the nut very tight to seat the bearings then back off nut tighten the nut " hand tight plus 1/4 turn and install the cotter pin....remove the top off of the break fluid resivor and some kind of squeezing device to push the pucks back in and have plenty of cloths under the resavor in case fluid pumps over,install the pads and clips and caliper then the wheel . you may want to put some brake anti-squeel on the back of the pads before you install then.............good luck ERh
Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.
( 2 rotors on the front ) one for each DISC brake
if you are driving and you go to stop, then that means that the front rotors are warped. if the front rotors are bad, you will feel a pulsation in pedal while applying brakes. change rotors on front.
Have the front rotors turned on a lathe at a dealership. check brakes and rotors
You will find that the front brake rotors are located behind the front of your wheel spindle, (behind your wheel and brakes). There you will see the rotors.
The front rotors are out of round or warped, Need to have the rotors turned.
Check front pads and brake rotors. You might have to change the pads.
Yes. Rotors on front brakes, drums on rear.
Your rotors are warped, replace them.
warped rotors
The front brakes and rotors on a 92 Hyundai excel need to function properly to insure that the car stops quickly. A front brake problem can cause an accident or personal injury.
Front rotors warped or out of round. Have rotors turned and that will fix your problems.