0
Add your answer:
Earn +20 pts
What is normal oil pressure for 1987 Corvette?
what is the normal oil pressure on a 1987 corvette when standing still
Oil pressure is reading high on corvette but oil is at correct level. Does this indicate a bad sensor switch?
High oil pressure is good....
Why does your 1998 Corvette continue to blow the oil sensor pressure gage?
== ==
Where is the oil pressure switch on a 2000 Corvette?
It is on the back of the motor under the intake.
What is ths max's oil pressure on a 1986 corvette?
Max's brother is Adam && Eve.
Where is the oil pressure sender in a 1980 Chevrolet Corvette?
at the top rear of the engine, behind distributer
Oil pressure drops raises?
Correct. The oil pressure does fluctuate throughout the RPM range.
Location of Oil Pressure Sender 1980 Corvette?
its the valve just above the oil filter with one lead coming off of it
Normal oil pressure for a c5 Corvette my Corvette seems to have higher then normal pressure at idle its about 60 psi should i be worried or do anything?
c5 corvette has bad sending units[ engineer world its called a transducer], $600 to replace since the intake manifold has to be R & R ALSO, when cold the Oil pressure will be in the 70 psi range then when hot, on a stock c5 this happens quickly because GM designed the car to run hot to paSS EMMISSIONS, IT WILL DROP TO APPROX 20 PSI. Normal operationg oil pressure for a 1999 corvette should be anywhere for 50 to 60 psi depending on oil one is using.
What is the function of a vtec oil pressure switch?
The vtec oil pressure switch tells the computer when the engine has the correct amount of oil pressure for the vtec to engage.
Where is the oil pressure switch located on the engine on a 1998 corvette?
IT IS LOCATED IN THE REAR OF THE INTAKE... YOU HAVE TO REMOVE THE INTAKE TO CHANGE IT....
How do you get change engine oil light to go out after you change oil?
If the light was on before you changed the oil and you now have the correct amount of oil, and correct viscosity, then it can be that your oil pump is defective. not putting out enough pressure. if you have an oil gauge, if that shows oil pressure is OK, then your light can be shorted out.
