CRANK KEYS There is no keyway in the hub for the harmonic balancer, so GM used a special cutback key that was flush with the front of the timing gear on the 1992-
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
Yes. It is in the distributer. Remove the cap and motor and you will see it.
from under the truck look up at the front of the motor and it is right there above the harmonic balance. It is one two wire plug and a 10 mm bolt holds it in
the crankshaft position sensor is located at the underneath side of the engine right at the bottom of the timing chain cover / front of oil pan
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
A 93 does not have a crank or cam sensor. Ask your question again. Tell us why you think it had a bad sensor, Tell us your symptons too.
The CMP is located on the engine front cover near the water pump. The wiring connector is at a 90Dg. angle to the sensor. It is a two wire connector and the sensor has a timing pointer attached to it.
The 1989 Chevrolet 350 cubic inch engine coolant sensor is located on the front of the engine. The coolant sensor will be near the thermostat housing.
it is under the roter cap.
The RSC sensor is located on the steering collum, Under the dash by the Optic Wheel.
upon the transmission
It is on the side of the throttle body opposite the throttle cable.