it should be right above your coil Its connected into the coil but mine was actually mounted on the passenger side firewall. its the only wire with a small harness.
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
I have a 92 lumina with a 3.1 and I found the crank sensor to be located on the passenger side of the engine in the back of the engine NOT on the side of the engine below the knock sensor. Hello, in my experience, all O2 sensors are located in the exhaust just after the manifold. It appears easy enough to change. If it is the crank position sensor you are looking for, take a look around the main pulley at the bottom of the engine, you may see a square-ish component located close to the actual pulley wheel, this would be the crank position sensor, it should have wires connected to it.
Knock Sensor On your 1992 Toyota Truck Previa 2WD (2.4L FI DOHC), the Knock Sensor is located: Front seating area, center, under engine cover, passenger side of engine, under intake manifold, mounted in engine block
no
GM have the codes. these keys and codes are very very expensive to replace GM seems to think if you can afford a key with a chip, u have lots of money
on the transmission tailshaft housing
It's located just before the oil filter.
The 91 has the 4.6L engine and has a MAF sensor located just after the air filter box so it has no MAP sensor.
On a Prelude 91 Si, you can find the MAP sensor by looking at the black box which is mounted on the passenger side firewall. You should see vacuum lines that run to it.
Hey, I got a 91' firebird 305 tbi that had the same exact problem...it's your speed sensor or O2 sensor....(or both)
Any size SBC engine will fit and is compatible with a 91 Firebird. A 350 engine is the most common that is used for installing in a 91 Firebird.
The intake rear...next to Alternator...This is what I have found out.
Cam sensor not used on '91 Tempo. Only introduced in '92 model year.
There is no such thing!!
in the ecu
engine map is a graph of an engine each part and where they are located engine map range 91 Chevy s10 pickup truck engine map is a graph of an engine each part and where they are located engine map range 91 Chevy s10 pickup truck
it should be on top of the engine on the passenger side.