Check the control arm bushings. There are some serious suspension problems that should be resolved before you drive much more.
Most likely,your CV axle(s) are bad. You will need to replace the axle(s).This happens as the vehicle gets more miles on it.
tie rod
Bad U-Joint
Wheel bearings or u joints
If there is a clunking sound when turning a vehicle, the problem might be the ball joints in the front end. The ball joints help to support the A-Frame which helps to keep the wheel on and upright.
replace c/v joints
Defective CV joint or bad wheel bearing.
You probably need your bearings repacked
Could be many things, ball joints usually make clunking noises (usually one when turning and one when turning the wheel from turning), cv joints usually make a clicking noise and vibrate under load. Have it checked out, les schwab will do it for free (check it).
When turning the wheel, a clunk means a tie rod or ball joint is worn out.
loose or bad u joints.
CHECK THE EXHAUST.MINE WAS HITTING THE BODY AT BOTTOM OF REAR FENDER