switch is bad DON'T ALWAYS LISTEN TO MECHANICS, YOU CAN FIX IT YOURSELF. The contacts from your blinker switch are dirty. Here is a forum that tells you exactly how to clean it http://www.grandamgt.com/forum/showthread.php?t=50126&highlight=clicking+signal+light
Blinker box is located directly above the fuse box under the dash on the driver's side. It is a square module accessible once the kick panel is removed. Very easy.
The hub has to be removed and the new bearing pressed in and the old bearing pressed out. This is not a job for the do it yourselfer.
Open Hood, Remove single screw from top of Blinker or Marker Light. Once Removed slowly pull lens out and you should be able to get to bulbs from there once you turn connectors and remove from Lens Assy
The disassembly button on an M9 firearm is typically pressed when the user wants to field strip the weapon for cleaning or maintenance. It is pressed after ensuring the weapon is unloaded and the slide is pulled to the rear. The button is then pressed, allowing the slide to be released and removed from the frame.
Not much info to go on but with most bushings the part has to be removed from the vehicle and the old bushing is pressed out and the new one is pressed in.
The headlight assembly has 3 screws that need removed. After removing the screws, then remove the headlight. The turn signal is located in the side light assembly. The blinker or turn signal assebly will pull forward and come out. After pulling it forward you can unsnap the wire and turn the blinker bulb, loosening it, then remove and replace. Be careful replacing the blinker assembly. There is a small part that "snaps" together when it is installed properly. If you do not install properly it will be O.K. but will not be lined up correctly.
hash (hashish): is THC tricomes/ "pollen" that has been shaken and or removed from the mj bud/leaves and the "pollen" is pressed and lightly melted it is the Leafs just chopped up and pressed (wrong)
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
There are 2 torex screws on the side that have to be removed. You have to open the tailgate to see these screws, once removed the taillight can be removed. It takes a bit of force however, there are also two pins that align it.
The front ones are removed with 2 screws and the side one can by removed by sliding the casing out and changing the bulbs. If you are any good at solving problems you can figure this out using a screw driver and pliers. Good Luck
The hub will need to be removed and the stud pressed or drilled out to be replaced.
If the blinker, or turn indicator bulb is in the lower portion of the front bumper, simply squat down, reach behind the front bumper, and "twist the bulb out" in the left loosey direction, the bulb can then be removed from it's socket and changed. If it is mounted on the fender next to the headlight, you need to remove the bezel surrounding the headlight and possibly the headlight it self. once the bezel is removed the bulb is easily changed.