0
2001 Kia spectra Mushy brakes after new calipers drums and master cylinder replaced whats the issue?
Wiki User
∙ 16y ago
Air in system? Remove and bench bleed master cylinder Bleed lines and calipers
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Front brakes are dragging replaced pads rotors calipers and lines but brakes still drag what could it be?
It's rare....because usually the master cylinder will allow pressure to bleed off. Not the other way around. But if you have replaced the calipers, this is the next thing I would check. I suppose it could be sticking.
Why are the front brakes sticking on your 1992 Ford F250 after you have replaced brake rotors pads calipers brake hoses and master cylinder?
have you tried the proportioning valve. sometimes dirt will get in there and clog the returns.
Your 1992 Corvette brakes slowly as if the rotors are glazed you have turned the rotors new pads replaced the master cylinder and vacuum booster Any other ideas?
Make sure calipers aren't frozen
Can't apply brakes in 2001 Honda accord?
could be the master cylinder. or the calipers may be siezed
Why would you have no brake pressure after replacing brakes rotors calipers and after bleeding the brakes on a 1991 cutlass supreme?
Bleed the master cylinder.& then rebleed the system.
Ford Tempo front brakes locking up?
I am having the same problem. Ist time overhauled calipers. Right front pads wore out quickly. Next replaced calipers, same deal right front is locked to the point where care shakes and cannot be driven. Thinking proportioning valve or master cylinder? Anyone ever run into this?
After changing pads and master-cylinder front brakes are trying to lockup on a 1988 Surburban 4x4 What should be done next?
Check the calipers. If the calipers pistons are extended to far - this could cause the brakes to lock up. The pistons cannot be retracted.
You replaced the master cylinder got new brake calipers and car still doesn't stop already bled brakes?
It would be helpful to know: What vehicle you are working on. The condition of the rear brakes, and were they also bled. Does the brake fluid level stay full, if no then there may be a brake fluid leak.
Replace rear brake padsrotors and calipers as well as master cylinder and pcv and bled the brakes but still the pedal goes to the floor what next?
If You Replaced the master cylinder Did you Bleed it as well? if not you need to bleed it first. then bleed the brakes start with the passenger side rear, then driver side rear, then passenger side front, then finally the driver side front.
Brakes sticking on and smell of burning already replaced the abs pump and put on new brakes and its gone and done it again?
I had one do this and I had to change the brake calipers. Problem was gone.
What causes rear brakes to scrub on a 1997 crown vic?
If by scrub you mean drag or cease, then it is possible that the calipers need to be replaced.
Do you have to lube brakes and calipers?
no
