First check out if the key isn't worn out. If not, more than likely the tumbler is worn out.
try putting transmission in neutral, then try ignition also check to see if steering wheel is not turned and applying pressure on steering lock in column to do this try to move steering wheel if this is problem it will only move one way , which would be in direction needed to straighten wheels.if it doesnt move one way but does the other way, when you move steering wheel u should be able to use ignition switch
If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
it probably doesnt have a steering column tilt on it
if you are changing the ignition cylinder you need to remove the steering wheel and dig down to the lock cylinder that way. do becareful you will need a special tool to reinstall components under steering wheel. I had to replace mine when the wire broke that reads the chip in the key The special tool he is speaking of is called a spring depressor.
First of all he DOESNT smoke ! And second of all he DOESNT have problems !
mine doesnt
ignition coil.i had the same problem
you need to replace your ignition in the steering column or take it apart and rebuild it. having a locksmith work on it might cost you less then replacing it though.
no, mine doesnt
It's not supposed to.
some models dont tilt... mine doesnt
it doesnt