attach the green wire to the negative terminal of the coil. if its an hei, it will have a terminal that says tach on it.
the green is the signal wire and it goes to the negative side of the ignition coil
Connect the green wire to the brown striped black wire.
Connect the green wire to the negative side of the coil.
Factory Green was created in 2007.
No. Aveo comes with the green stuff in it.
Switch ignition on connect LED test lamp between terminal 7 of the diagnostic connector and earth after 3 seconds 5 green LEDs will illuminate Switch ignition off.
Switch ignition on. Connect an LED test light between terminal 7 and earth. After 3 seconds 5 green LEDs will illuminate. Switch ignition off.
factory
for level 5 on factory balls is: green, pump, blue, pump, green for level 5 on factory balls 2 is: yellow, black spray 2x, hat on, green, hat off
Get an RPM meter (tachometer) for 1 cylinder 4 stroke engine to match with your engine. Connect ground wire from RPM to body, usually black colored wire. Connect power wire to ignition switch, make sure it is connected to 'ON' position of switch, this wire usually with yellow insulation. Connect green wire to coil negative terminal, this terminal is connected to contact point or ignition trigger system, the wire from tachometer is usually with green insulation. Start your engine and check RPM reading.
green plants
green plants