answersLogoWhite

0


Best Answer
Copy

The two locations it could be are

1. Top rear of engine next to distributor

2. Bottom drivers side of engine above the oil filter.

The second option is more likely as it was moved to this location on most vehicles in the early to mid 80s.

User Avatar

Wiki User

โˆ™ 2010-02-12 04:25:49
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: 89 Chevy 305 oil sending unit location?
Write your answer...
Submit

Related Questions

Where is the Temperature sending unit located on a 1988 Chevy 305?

connected to thermostat housing


Where is the temp sending unit on a 1987 Chevy 305?

it is located on the bottom end of the head


What color wire comes from fuel sending unit Chevy 305 tbi?

A tan/white wire goes from the sending unit to the fuel gauge typically on a (example) 1985 Chevrolet Silverado 305 tbi.


Where is the water temp sending unit on a 305 small block Chevy?

it screws into the side of one of the heads.


What is causing low oil pressure at the gauge on a Chevy 305?

most likely a sending unit problem


What is the sencer located next to the oil filter on a 1986 305 Chevy motor?

That would be the oil sending unit.


Where is the 89 Chevy 305 oil pressure sending unit located?

On the drivers side of the block, right above the oil filter.


Where is my oil pressure sending unit on 1987 305 Chevy?

Just read somewhere else that it's at the back of the motor under the distributor.


Where is the Temperature Sending Unit on a 1977 Chevy 305?

It's usually screwed into the intake manifold towards the front, near the thermostat housing.


What is the tempatura sending unit part number for an 84 Chevy 305?

To tell you what the temperature sending unit part number is I would need more information. It all depends on what type of vehicle it is in, and where that models actualy hooks up at.


Where is the oil pressure sending unit located on a 1995 Chevy K-1500 305?

The oil pressure sending unit is located under the hood, way in back of the engine, under the distributor on the drivers side. Removal requires removal of the distributor.


Where besides near the distributor is the oil pressure sending unit on a 1983 Chevy 305?

On drivers side screwed into the back of block behind intake with 1wire plugged on to it.


Location of number 1 cylinder on chevy 305?

Front driver side.


Where is the Temperature sensor sending unit located on a 1982 Chevy 305?

It should be in the thermostat housing or right next to it a single wire normally right side or center on front of intake manifold.


Where else can you put a oil sending unit on a Chevy 305?

There's a pipe plug just above the oil filter. The readings might fluctuate a little more, but it would work fine.


Where can you find a schematic of a 83 305 Chevy engine?

The schematic for an 83 Chevy 305 engine can be found in the service manual. It gives the location of each component and how everything is connected.


Chevy 305 filter location?

driver side at rear of engine under neath


Where is the coil location 1983 Chevy 305?

It's sitting on top of the distributor cap.


Where is the oil sending unit located on a 1989 Chevy Camaro RS with a 305 engine?

I believe it is located right above the oil filter. It screws into the motor block and will have 3 wires attached to it with a plug.


Where is the location for a oil sensor for 1985 caprice classic V8 305?

the bottom right side The oil pressure sending unit that makes either the light or gauge work is located behind the distributor.


Where is the oil sending unit located on a 1986 Chevrolet Pickup with a 305 Engine?

it is located behind the distributor on top of the block there is the oil sending unit and a oil sending switch with a wire that goes to your choke if it is electric trace it back and you will find it...


Are the motor mounts for a Buick 305 the same as a Chevy 350?

If the Buick 305 is really a Chevy 305, then the motor mounts will interchange with a Chevy 350.


A 1989 305 what is the cylinder shaped thing above the oil filter with a spot for a plug on it?

OIL PRESSURE SENDING UNIT


Where is the oil sending unit 305 engine Chevrolet engine 1986 pickup?

top rear of the motor, next to the distributor


1978 Chevy 305 oil sender location?

It should be in the back of the engine, just to the drivers side of the distributor.