No, the pump can be changed without dropping or removing the engine.
no, u need to remove the heads to get at the lifters
I did it, just supported transmission and changed engine just like any other car.
To put a straight six in a 93 Ranger the engine will have to bolt up to the transmission or the bell housing will have to be changed. The engine mounting brackets will probably need to be modified, and the wiring for engine sensors will have to be changed for any connector differences.
that depends on what car you are working on
You are better taking off the engine with the transmission together, I have a 93' Vigor and changed the transmission and it pretty hard, there many bolts that are hard to get; if you need to changed your engine, it will be much easier taking the transmission off while the engine is off the vehicle..
The oil pan on a 92 Ford Ranger is removed by taking out by placing a drain pan under the engine, removing the retaining bolts, and prying the pan loose. It can then be lowed from the engine and removed.
yes when the engine is out and upside down
You gotta go from underneath the truck between the frame and the engine and its good to have a friend with long skinny arms to do this.
2.3 L engine in a 1998 Ranger???? The 2.5 L cam belt should be changed at 120,000 miles.
Any four liter engine should work in your 1994 Ford Ranger cup truck. The Ford four liter engine may need the motor mounts to be changed.
A 1985 Ford Ranger ( all engine sizes ) came WITH and WITHOUT air conditioning
Yes, the engine will pull right out without removing the trans.
In some cars, you can get the rear bearing by dropping the transmission. For the rest, no.
The fluid is drained by removing the transmission pan.
Without removing and disassembling the engine, Sea Foam oil treatment is a good product for this.
yes i am sure this looks like a daunting task however 75% of engine accesories can be replaced without engine removal.
A little more information please Size of engine , with or without air conditioning in your 1997 Ford Ranger
The oil pressure switch is located at the back of the engine next to the distributor. Looking at it from the front of truck it will be right of distributor. Normally it can be changed without removing the distributor.
A 5.0 liter engine will fit in a 1994 Ford Ranger with some modifications. The position of the transmission, motor mounts, and wiring will all need to be changed.
If you are debating on whether or not you want to buy a Ford Ranger, then it is useful to know the engine size. The Ford Ranger is available, with a V6 engine.
can the fuel injectors on a 1994 grand marquis be checked without removing them from the engine, if so what type of instrument do i use