No such engine as a Pontiac 400 Big Block.
The back of the Pontiac engine block has a different bell-housing bolt pattern than the Chevrolet. Pontiac and Olds bell-housing bolt pattern match. Chevrolet and Buick match. Unless you have a dual bolt pattern transmission (GM did make them) the Pontiac engine won't bolt up to the the Chevrolet transmission.
If you are asking if a small block chevy V8 flywheel (most common engine in a 1967 Camaro) will work on a Pontiac V8 (most common engine in a lemans), the answer is no.
1968 327 SBC (probably out of a Camaro)
yes. that is one of several blocks used for the 302.
looking for a fuse panel block 2008 pontiac
The firing order for the Pontiac 400 engine is that the small block powers the big block.
The Pontiac G6 block heater is located on the right hand side of the engine. The block heater can be located by following the block heater cord.
The casting block number indicates that it could have come from a number of vehicles that have a GM 350 small block from 1985 to 1997. Suburban,corvette, camaro, ect. The same block is also used on several marine applications
I can't find my block heater plug on my pontiac G6 2006,,,Where is it? Maybe it does not have a block heater.
Fully dressed a Pontiac block will weigh in around 600-650 lbs. If you are asking about the bare block....I honestly don't know.
According to that block number, it should be a 1980-1985 305 V8. So to answer your question; Any starter for a 1980-1985 Malibu, Camaro, Caprice, or Pickup should be the correct one.
First its not called a big block, Pontiac never made a small block. it is just called a Pontiac 350. as far as tourque i t ranges from 150 to 400 depending on the year and trim
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.