no id doesn't require a special trick just remove the 3 bolts that hold the Power Steering pump and it will give u acess to the water pump placing it on is the hard part
Many vehicles will only require your basic tools but there are some out there that require special tools such as the Cadillac with the North Star engine.
No switch. Check the relay for the fuel pump.
You will need a GOOD pitman arm puller.
Disconnect the battery. Remove the steering wheel. Remove turn signal switch,Remove the buzzer switch with needle nose pliers. Then insert the key(make sure it is not in place beforehand) and place in lock position. remove lock cylinder retaining torx screw. Then with key in place, pull out the assembly straight out.Disconnect the electrical connector from the bulkhead connectorand remove retaining clip. attach some wire to the connector to help with installation and pull harness through column. Installation is reverse.
Well that really depends on the condition of your elders. Those who have special needs will require special care, like those who are disable or are inflicted with chronic diseases or condition may have need caregivers, or be transferred to nursing homes, or in assisted living facilities
Remove the steering wheel and disassemble the wheel lock mechanism. This requires removal of the air bag and some special tools.
Depends on the year of your BMW, and the style of power steering rack. There are 2 common types: 1) Electronic Power Steering (EPS) 2) Hydraulic Power Steering (HPS). EPS does not require fluid and HPS does require fluid.
You will need a steering wheel puller and a steering lock removal tool You rent them at yourlocal auto parts store
You have to remove the steering wheel ,lockplate, turn signal assembly and you will get to four bolts that are loose. Go to your local auto patrs store and tell them you need the special tool (lockplate removal tool and steering wheel puller)for GM steering colums.
Most power steering pulleys require a special tool to remove and replace. Many auto parts stores will rent you the proper tools to do the job.
You need a special pulley removal tool. And you will also need a special tool to reinstall the pulley. You might be able to buy one at your local parts store.
You need to get a special tool, steering wheel puller. If you have it, disconnect the battery. Remove the steering wheel air bag (there are two screws holding it in place). Disconnect the bag harness. Remove the center steering wheel nut. Using the puller remove the steering wheel. Installation is reversed to removal.
The power steering pulley requires a special puller to remove and install the pulley. Many auto parts stores will sell or rent you the proper tool. Any attempt to remove the pulley without the special tools will probably damage the pulley and or the pump.
it takes a special tool You can probally rent the power steering pulley removal tool from auto zone are any other reliable parts house. You will also need the tool to re-install the pulley.
no. you can use any oil in the engine. But only use GM supercharger oil for the supercharger.
Frankly, any parts store power steering fluid will work fine in this application. GM uses robust power steering pumps, and they do not require any special fluid. However, do not use transmission fluid, it does not have the appropriate anti-foam additives, and can cause pump cavitation, which will damage the pump.
The Power steering hose is attached with a quick-connect that requires a Quick-Connect removal tool that should be available from you local auto-supply store. You need to know the diameter of the tubing / hose connection. There may be a universal tool for a range of sizes.