Oxygen Sensors
Mazda 626
Ford Expedition
Ford Expedition XLT

Does the 1994 Mazda 626 transmission have sensors and if so how many and where located?

666768

Top Answer
User Avatar
Wiki User
2015-07-15 18:25:49
2015-07-15 18:25:49

sure do they got four ..one on the left ..one on the right ..one in the front..and one in the back

this year has a vehicle speed sensor mounted on the transmission. I believe that the 4 sensors mentioned would be abs sensors, replacement of them should be done by a trained profeffional.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the input and output speed sensors are on th driver side of the transmission located one on each side of the dipstick

User Avatar

its just above the transmission in between the cylinder heads

User Avatar

Try replacing both transmission speed sensors (around $20 each located on transmission)

User Avatar

there is no dip stick for a manual transmission .there is a bolt on the side of the trans you have to pull then stick your finger in ..if you can touch it its ok

User Avatar

Dexron II (or III) is the recommended automatic transmission fluid for a 1994 Mazda Navajo. It requires 3 quarts to do a fluid change.

User Avatar

On the top of the transmission, with a harness headed to it, should be about 3 bolts to take off, then valve comes off... shift solenoids are in there

User Avatar

transmission fluid is in the transmission

User Avatar

It is located on the right, behind and to the left of the battery, about 6 inches below the top of the engine. It is really hard to get to.

User Avatar

Instructions on how to remove a 1994 B4000 Mazda 4 wheel drive transmission

User Avatar

The 1994 Mazda 626 was built with 4 and 6-cylinder option models. The CD4E transmission has a fill of 7.4-quarts (qts). The GF4A-EL has a larger capacity of 9.3-qts.

User Avatar

where is the inertia switch on a 626 maza 1994

User Avatar

is under the transmission stick console, heres a web page for mre info. http://www.scribd.com/doc/51604740/Mazda-Protege-Workshop-Manual-1994-1998R-English

User Avatar

A 1994 Mazda Miata's automatic transmission may slip in 4th gear if the bands are heavily worn. When the bands become worn, they are unable to grip properly and cause slippage.

User Avatar

The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.

User Avatar

Inside the transmission, just above the transmission oil pan.

User Avatar

the alternator is located under the inlet manifold

User Avatar

It is inside the transmission on top of the valve body.

User Avatar

Inside the transmission, just above the pan.

User Avatar

the switch is located in or on the transmission case

User Avatar

The 1994 Mazda 929 dryer receiver is located on the firewall in the engine compartment. The dryer receiver will be on the passenger side of the firewall.

User Avatar

The sensor on the 1994 Chevy Caprice is located on the transmission. it is mounted on the tail shaft of the transmission.

User Avatar

Have your Mazda dealer parts department print out a picture of the relays location for you. They will do this if you ask them.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.