I found the IAC valve on the throttle body right below the air cleaner and above the EGR valve. I removed it with a large wrench, 1 1/4" if I recall correctly and sprayed it down with carb cleaner and scrubbed it with a brush. I will probably use electrical contact cleaner spray the next time I clean it so I won't have to worry about the contacts.
98 chevy lddle control valve
how can I clean the Idle Air Control Valve on a 1998 Nissan Frontier
my 2002 volvo s-40 is miss firing and it is alleged that the fault is from the idle air control valve. how can i clean the valve?
no just replace the valve
on side of throttle body!it is round and has 3 wires going to it is black,it is operated by the ecm,you can take it off and clean it with carb cleaner,with a fine toothbrush do not put valve body in solvent clean just the valve itself!! on v6. do not push on valve it will change setting,it measures 1and 1 /8th from body to tip of valve
Yes, you can clean the PCV valve. Take off the PCV valve and get a spray can of carb cleaner. Just spray into the valve and just enough to clean out any gunk that might be in there. You should hear it rattle when you shake the valve.
Clean the Idle air control valve with carburettor cleaner. If it doesn't fix the issue replace the IAC.
no its sealed
The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.
clean or replace your idle air control valve.
idle air control valve error.... try to clean it up
Clean the throttle body or replace the idle air control valve