you will need a steering wheel puller and a laock plate remover. it is almost impossible to do this without a lock plate remover
how to remove cover to replace ignition lock cylinder and what type of tools do i need
call a lock smith .
The retaining clip on the end of the post that the switch is located on - how do you remove it?
Remove the retaining ring from the top of your 1997 Chevrolet 1500 ignition cylinder. Slide the ignition cylinder out and remove the wiring harness.
how to remove and replace transmission fluid pressure switch on a 2002 dodge ram 1500
If you take the vin number and proof of ownership you can go to a Chevrolet dealer and they can cut you a new key. I kinda think the OP is asking how to remove the Ignition Switch. You need the key to remove the switch without drilling and making a mess of the housing.
Do you take the steering wheel off to get to the ignition
you have to replace the whole module if I am not mistaken, first remove the steering wheel cover and then there should be 2 pins you will have to get to and push simultaneously to remove
1995 & 1996 checy trycks used a two piece ignition switch. I had this same problem and replace a bunch of stuff to find out the ignition switch was intermitting shutting the truck down so check before you spend money on parts you don't need
To replace the brake light switch on a 1995 GMC Sierra 1500, the steering wheel will have to be dismantled until the brake light switch is reached. The switch is changed by unplugging it and plugging in a new one. There are screws holding the switch in place.
The "halo" is the lighted ring around where the ignition key goes into the key cylinder for the ignition switch.The "halo" is the lighted ring around where the ignition key goes into the key cylinder for the ignition switch.
no