what is causing the door not to open? is the inner pull handle broken, is it the locking system? At times you have to make drastic choices did u see saw? Anyways if it is the inner pull hadle that is broken you can take it off with a screw driver then there is a a rod with a 90 deg angle that catches on to the pull release it unlatching the little clip holding it to the door pull,then pull the rod towards the front of the car this should get it open. You can then replace the door pull for 13 bucks or so. If this does not work first check the price and availability of the inner door cover at the junk yard the use a box cutter to cut open the inner skin(the end towards the keyhole) to gain access to the entire locking mechanism. Open your door from there, the replace the skin with the replacement you would have bought.
It is impossible to remove the inner skin without opening as there are about 3 -4 screws that secure it from the base (check other door). So you have to destroy what is fine to move on
A door panel on a Hyundai is secured with several screws. Loosen and remove and the screws then proceed to gently pull the panel outward. There are several clips for extra support. Pull the panel outward and the clips will come off as well.
You can find a fuse panel diagram for a 2002 Hyundai Sonata in the vehicle's owner's manual. You can also find it at select auto stores.
Remove the liftgate inner trim panel.Remove the liftgate inner trim panel.
rear door panel ,how to open.
A door panel on a 2005 Hyundai Accent is mounted with screws and clips. Loosen all the mounting screws. Pull the panel outward and pop out the clips. Remove the door panel.
It could be the fuse. See the related question.
remove the dash board panel around it and take it out
ARE YOU TALKING ABOUT DR PANELS? if so you have screws that is cover up by small caps that is the same color that the dr panel is,remove and you will see the screws a long side of dr and under the dr panel. THE BLACK CAP by the mirror just pop off.There is a screw under the dr handler cover up by a cap remove with a small blade screw driver and the panel will come off. //
Drill the rivets out.
remove the inner door panel, you can access the bolts from the inside of the door.
I have a 1999 Sonata, and my fuse panel is underneath dash on drivers side. It is to the left underneath dash, kind of hard to see, but easy to get to.
How do you remove front door Panel on Hyundai Excel 1999 to Rplace front door SPEAKER'S
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
The inside door panel cannot be removed; instead, to get to the inner workings of the door remove the OUTER panel. Lift the outer door handle to expose the pins that hold the outer handle to the door mechanism. Then press out the pins and remove the handle. Then remove the screws around the perimeter of the door that hold the outer panel. The panel should lift off, exposing all of the inner workings, then you can verify that the inner panel does NOT come off.
The fuse panel diagram for this car can be found in the owners manual of the car. It can also be found on the back side of the cover of the fuse box.
Remove rear seat, there is an access panel for the fuel filter. Remove access panel and have access to fuel filter.
remove inner door panel for access to lock
Open driver's door, fuse cover is to the left from the steering wheel on the front panel (it is covered by the door when door is closed)
remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
Clips hold the door panel in place. To remove the panel, you will need a small pry bar and apply gentle pressure to the gap between the panel and the inner part of the door.
you allow your bait car
It isn't an easy job as you have to remove the inner finder panel.
i have a 2004 Toyota tundra double cab i want to remove passenger door panel to tight door handle