Loosen 13mm nut that secures tension pulley. Then loosen 13mm nut/bolt just above tensioner assembly facing upwards, to remove tension from belt. Then finally remove the three 10mm bolts holding tensioner assembly to engine block. Install in reverse order.
replace 1996 nissan 200sx se 1.6 tension pulley
3 bolts above your oil filter may have to move belt a
The tension pulley should have a bolt that holds it on, allowing you to replace the unit.
The 1996 Nissan Maxima timing marks can be found on the main pulley, on the front of the engine. The timing marks will be scattered around the outside of the pulley.
it is time to change bearing on that pulley
It will depend the year of the maxima if one is available at all......................
loosen the tension pulley bolt which is in the middle of the pulley, use a wrench, little work space is provided, just a little bit, then lossen the bolt that is behind the pulley, tho relive tension in the belt. take off the belt, and put on new one and tighten the bolt behind the pulley till belt is tight, then retighten the pulley bolt.
you don't tighten a serpentine belt the tension is supplied by a tension pulley if belt is loose, it is time to replace belt or tension pully if tension pully needs repplacing belt will be worn anyway
Begin by loosening the tensioner pulley on the front of your 1996 Nissan Maxima engine. Slide the tensioner pulley to the right. The old power steering belt will become loose and can be removed. Put the new power steering belt on. Tighten the power steering belt by sliding the tensioner pulley to the left.
When It no longer hold proper tension if the belt is squeaking then it is probably time to change it
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
The zd30 has a hydraulic tensioner using an idler pulley to automatically tension the serpentine belt.
most cars have an adjuster pulley where you can tighten the belt and also replaceit as well.
Disconnect the battery.remove the serpentine belt.Unbolt the pulley.
Replace the tensioner assembly as one piece.
Call the parts store. They will be able to tell you if the pulley is available separately or not.
There is either a tensioner or an adjustment screw on a pulley. A Haynes manual or Chiltons manual will help with the routing of the belt, and how to adjust the belt tension as well. Usually the idler pulley is used, before loosening the top bolt , loosen the center bolt of the pulley.
Use a 15 mm socket to loosen the tension pulley... take the old belt off and replace with new belt.. then gentle pry up on the tension pulley and lock bolt back down..
There should be a "square" cut into the pulley bracket that fits either a 1/2 inch or 3/8 inch ratchet or breaker bar to allow you to remove tension from this pulley allowing you to replace the serpentine belt.
with a 9/16 socket and ratchet
Check the tension on the belt. A power steering pump will whine if there is too much belt tension, putting pressure on the side of the pulley.
The alternator on a 2001 Nissan Sentra is replaced by loosening the serpentine belt tension, loosening the alternator bolts, and slipping the belt off the pulley. The alternator can then be unbolted, the wiring harness disconnected, and a new alternator put in place.
replace the belt with a goodyear bet
the water pump is in the middle of the timing cover the crank pulley and timing cover has to come off