yoy need someone to pump the peddel like you are bleeding brakes. there should be a bleeder screw on the slave. loosen it and let the fluid come out, then retighnt it. repeat un till all air is out. make shure uoy keep the resovior full at all times.
how do I bleed the clutch system in a 2004 ford ranger
well mines not a ranger its a ford f250 super cab 7.5 l now how do i stop the clutch pedle from going to the floor
The slave cylinder for your hydraulic clutch is inside the transmission bellhousing
On the drivers side of the transmission bellhousing Check out : www . the ranger station . com ( no spaces ) Click on Tech Library Under the manual transmission section they have a good write-up on how to bleed a hydraulic clutch
you don't adjust it. It is a Hydraulic clutch unit. you have to bleed it. There is a 7/16" bleeder valve on the transmission. clay Colorado
It should be on the bell housing above the hydrolic hose, mine had a rubber cap covering it.
bleed clutch Saturn vue 2003
fill the clutch resivoir pump the clutch pedal open the bleeder screw and tighten it back up and repeat until the air is out and just fluid comes out
Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.
You don't. The part (if it contains air) has to be replaced. If it's new.. it doesn't need bleeding.
Try this site. It helped me: http://www.miata.net/garage/mastercyl.html
how to i change a clutch in a 1993 ford ranger