0
You have to pull the transmission out to get into the cylinder. Jeep sells them for 240. but carquest sells em for just over a 100. Im putting a clutch at the same time and mines at 86000 miles. Probably not necessary to do the clutch but since its a 5.5 hour job in a shop might as well have it done too. 130. for the clutch disk and pressure plate . 500 for labor and doing the u joints at the same time since they need to come out to do it.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Do you have to pull motor to change the clutch slave cylinder?
Yes
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
How do you change the clutch slave cylinder in a 93 Ranger?
very carefully
What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
Where is the clutch slave cylinder on a 1994 pickup truck?
The clutch slave cylinder , for a hydraulic clutch , is inside the manual transmission bellhousing
Where is the clutch slave cylinder on a 1997 ford ranger?
The clutch slave cylinder for a hydraulic clutch is inside the manual transmission bellhousing
What does the master and slave cylinder do for the clutch?
The master clutch cylinder is attached to the clutch pedal. When one depresses the pedal hydraulic fluid is forced from the master cylinder through the hard line to the slave cylinder. The piston in the slave cylinder is driven against the clutch linkage thereby releasing the clutch.
What type of fluid does the clutch slave cylinder use in a 1998 Mitsubishi mirage?
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
Where is the slave cylinder?
It depends on the slave cylinder that you are asking about. The slave cylinder for a hydralic clutch would be neer the bell housing to disengage the clutch. The slave cylinder for drum brakes would be inside the drum between the two shoes, and pressure applied into this cylinder would engage the brakes.AnswerThe clutch slave is inside the bell housing on most of these. You have to pull the transmission etc to change it out. ANSWERSTRANSMISSION HOUSING OUTSIDE FLUID PIPE
Where is the bleeder on the clutch slave cylinder?
In cylinder
Where is the clutch master cylinder and slave cylinder on a 94 explorer xlt?
The clutch master cylinder is in the engine compartment and the slave cylinder for the hydraulic clutch is inside the manual transmission bellhousing
What connects slave cylinder to clutch pedal on 1987 ford ranger?
The clutch pedal assembly has a clutch rod that pushes in on a clutch master cylinder. There is a hydro line that goes from the master cylinder to the slave cylinder.
