answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change a passenger-side driveshaft on a 1989 LeMans with a 1.6L automatic?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change out the side mirror assembly?

how to replace passengerside outside mirror


How do you change manual transmission into automatic?

This is a major mechanical project. Remove the clutch and manual transmission and the radiator. Install automatic transmission, new driveshaft, new radiator. You have just spent as much as a car is worth.


How do you change the half shaft on a 95 Nissan Altima?

# Raise and support vehicle, then remove wheel. # Unfasten brake caliper assembly, leaving brake line attached. # Remove tie-rod ball joint from knuckle, then separate driveshaft from steering knuckle by tapping on driveshaft. When removing driveshafts, cover boots with cloth to prevent damage. # On models with automatic transaxle , if replacing both driveshafts, remove righthand driveshaft before removing lefthand driveshaft. # Use a large screwdriver to pry driveshaft out of transaxle. # Reverse procedure to install.


Can i put a 1992 Chevy pickup automatic transmisssion into your 1970 Chevy Camero?

You may need to change the length of the driveshaft, move the crossmember back some, and you may need a switch kit for the lock-up converter.


How do to change your 2001 land rover discovery driveshaft?

Mark driveshaft and yoke to re-isntall in same location to maintain factory balance Loosen and remove small "U" clamps at yoke end of driveshaft Pry driveshaft out of yoke Pull off of splined end


Will a 350 drive shaft fit a 400 transmission?

The splines on the transmissions were the driveshaft slides into are different on the 350 and 400 turbo's So that means you will have to change the yoke on the end of the driveshaft.


How do you change the alternator on a 1999 2.5 v6 vectra?

Answer this question...pop driveshaft out bud


How do you change transmission fluid on a 1972 Pontiac lemans?

you have to drop the entire pan since there is no plug and you might as well change the filter and gasket while you have it off


How do you change a timing belt for a 2.0 Liter 1990 Pontiac Lemans?

there is no 2.0l Pontiac lemans.it must be a swap from sunrunner.


How do you change the U joints in a 98 jimmy?

Mark drive shaft and yoke to re-install in the same location to maintain factory balance Remove and discard small "U" bolts that hold driveshaft Pry driveshaft out of yoke Drop driveshaft Bring to auto parts/machine shop to have "U" joint pressed into driveshaft Replace "U" bolts Re-install driveshaft in same position as removed


How do ichange harmonic balancer on driveshaft of 1997 ranger?

change car buy new one


How do you change u joints on a 1989 GMC sierra?

Mark driveshaft, yoke, and transmission tailpiece so driveshaft will be re-installed in same location to maintain factory balance Remove and discard small "U" bolts at differential yoke Pry driveshaft out of yoke and up on to transmission tailpiece Pull driveshaft off of transmission Easiest to bring driveshaft to auto parts/machine shop to have new "u" joint pressed into driveshaft Replace in reverse order using new "u" bolts