• Brakes and Tires
  • Brake Fluid and Lubrication
  • Brake Pads and Rotors

How do you change brake lines?

User Avatar

Wiki User

βˆ™ 2007-02-05 02:31:07

Best Answer

Brake jobs are not a job to be done without a Manual. Your life and the lives of others and the life of your Automobile depend on them.
[ Please purchase a Manual and do the job correctly]. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For Information & Contact Details.

2007-02-05 02:31:07
This answer is:
User Avatar

Your Answer


Related Questions

How do you change brake lines on a 1991 Buick lesabre?

How to change brake lines on a 1991 Buick Lesabre?

How do you change brake lines on a 92 buick lesabre?

How to repair brake lines on a 91 buick

How to replace Brake lines 1996 ford econoline e 150?

how to change brake lines on a 1996 ford econoline e-150

How do you change brake lines on a 95 Chevy lumina?


Your brakes feel light and there is brake fluid leaking from rear disk brake on a peugeot 106 1994?

change the wheel cylinders or the brake lines

How long does it take to change a brake master cylinder on 306?

Master Brake cylinder replaced and lines bled-how long?

Why is the brake pedal feel so low and spongy after a brake change on a 1995 Honda Civic?

You probably have air in the brake hydraulic line. Bleed the air out of the brake lines.

Why is the brake petal soft after you change the brake pads?

This is caused by the pressure release in the brake lines when you retract the pistons in the brake calipers to accommodate the new brake pads that are thicker than the ones that are removed.

What are the most common brake lines on a the Chevy Malibu?

Master cylinder brake lines are the most common brake lines on a the Chevy Malibu.

Can you use rubber fuel lines to replace your brake lines?

You can not use rubber fuel lines to replace the current brake lines due to the high operating pressure. You will need to replace them with brake lines, the rubber brake lines has a different construction to hold the pressure and not getting eaten away by the brake fluid, brake lines can hold over 2000psi when the pedal is heavily applied

How do you change the brake booster in a 1995 GMC Jimmy?

Begin by removing the brake lines from your 1995 GMC Jimmy brake booster. Remove the brake booster retaining bolts. Reverse the process to install your new brake booster.

Do you remove tires to replace brake lines?

You remove the wheels to replace brake lines.

Replacing rear brake lines 1999 Chevy blazer ls 4x4?

The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.

Where are brake lines in a car?

Brake lines run from the master brake cylinder to each wheel, generally under the frame of the car.

How do you change a brake cylinder on a 1999 Galant?

Drain the brake fluid from the brake master cylinder reservoir. Remove the wiring harness from the brake cylinder. Remove the brake lines. Remove the brake cylinder retaining nuts. Reverse the process to install the new master brake cylinder.

Where can you get a 1997 expedition 4wd brake line diagram?

It is important to have a diagram when making a change in the brake lines. A diagram for the 1997 Expedition 4wd brake line can be found in maintenance manual of the car.

What are the steps to change a master slave cylinder?

You are going to be bleeding the brake lines. removing hoses and lines on the master brake cylinder. Getting under the dash and removing the nuts that hold the thing on. Then reinstall in reverse order.

How to change brake fluid for ford escort?

You do not normally change brake fluid, only keep it at the proper level. There is sometimes a minimum and maximum level line. You should keep the level between those two lines.In other cars you just fill it all the way up. Be careful to not get dirt into the lines by first cleaning the outside before you open the lid.There is a process called bleeding the brake lines. This takes two people, one to loosen the the plug that is at the wheel and one person to pump the brake pedal. The air must be out of the brake lines for the hydraulics to be effective.

Are service brake lines and control brake lines the same thing on an air brake system?

The service brake is the one which applies the brakes - the emergency brake system is the system which releases the spring brakes.

What is the cost of replacing all of the brake lines on a 1995 Buick Park Ave?

Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.

How do you change 2003 Ford Explorer rear brake calipers?

Remove wheelsDisconnect the emergency brake cablesDisconnect the brake linesRemove caliper mounting boltsSlide caliper off rotor

Diagram of brake lines on 1993 topaz?

need diagram of rear brake lines for 1993 mercury topaz

How many brake lines does a 95 Ford Taurus need?

The 1995 Ford Taurus has four brake lines. There is a break line for each break. The brake lines go from the master cylinder to the brakes.

How do you fix squishy brakes on a 1997 couger?

You Probably have air in your brake lines Or you may have low brake fluid. Mechanics can bleed the brake lines which will remove the air out of the lines. I do not recommend doing this yourself.

How do you bleed the brake lines after replacing brake pads on a dodge Dakota?

If you did not open any brake lines and only replaced the pads there is no need to bleed the system.