answersLogoWhite
Auto Parts and Repairs
Clutches and Flywheels
Chevy Blazer
Chevy Blazer S-10

How do you change the clutch on a 1985 S-10 Chevy Blazer?

666768

Top Answer
User Avatar
Wiki User
2015-07-15 21:29:50
2015-07-15 21:29:50

It is best to get s shop manual on your car as it is a big job. The parts store should have one.

1

Related Questions

User Avatar

The overall length of a 1985 Chevy Blazer is 4,712 mm or 185.5 inches. Its curb weight is around 2075 kg.

User Avatar

over charging or bad bearings its about to let you stranded change it

User Avatar

You have a hydraulic clutch in your mr2, no cable.

User Avatar

check your regulator. it maybe over charging your battery

User Avatar

The 1985 Chevrolet S10 Blazer has a curb weight of 4,462 pounds. The standard fuel tank capacity for this vehicle is 24.83 gallons.

User Avatar

Its mounted on pulley system on t besi he front of the engine opposite the alternater for k5 blazer 1985 an in the same place from 79 to 87 years

User Avatar

I have a Chevy 350 from a 1985 blazer in my 1990 wrangler. So yes it is. I also have the transmission and transfer case from it in my jeep to.

User Avatar

no it not hard it should be the pulley the fan is bolted to. I changed mine a couple of weeks ago

User Avatar

The curb weight of the 1985 Chevrolet Blazer is listed as 3760 pounds. The curb weight does not include any fluids or accessories.

User Avatar

what is the wheel base for 1985 s10 blazer

User Avatar

It already has throttle body fuel injection.

User Avatar

The 1985 Chevrolet have blazer tail light fuse can be found in the fuse box. The fuse box is located beneath the drivers side dashboard.

User Avatar

Up front, under the power steering pump, not easy to get to.

User Avatar

you have to change the ring and pinon gars

User Avatar

inside driver frame rail under driver seat

User Avatar

No, you can't. transmissions bellhousing is different in 60° V6 and L4

User Avatar

Standing in the front of the engine, it will be on the left bottom side of the engine block up towards the front.

User Avatar

Through the filler pipe at the right rear of the engine. Check it when hot, with it on level ground and don't overfill it

User Avatar

Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.