As you stand in front of your Jeep, the radiator drain plug sticks out the bottom of the left side. With a large gathering container on the floor, loosen the drain plug with an open-end wrench (or more suitable tool if you have one) only until the coolant flows through the spout, it's made so you don't have to (or want to) completely remove it. Now empty, you can either use a flush-N-fill kit, or if you're on a budget, run water at moderate pressure through a garden hose at the radiator cap opening for 20-30 seconds and let it drain. Tighten the drain plug and refill with a good mix 60/40 or whatever's best for where you live. [Take care to refill slowly - even though OEM radiators are supposed to purge air pockets, I had already installed a new aftermarket radiator and didn't want to take any chances. Air pockets can cause cooling system malfunctions and engine damage in a general sense, I'm not enough of a technician to list specifics.] Good luck !
drain radiator. remove upper and lower hoses from radiator. if automatic, disconnect tansmission cooler lines. remove fan shroud, or electric fan,whichever applies. unbolt radiator supports and remove radiator.
the hard part is the lower transmission cooler line. you need a special tool, air conditioning line release tool. its a small plastic ring which is inserted under the flared fitting and depressed releasing the line.
When you add engine coolant to a 2003 Jeep Grand Cherokee because the low coolant indicator has come on, you should add to the reserve tank and the radiator if they are low. Sometimes, just the reserve tank needs filled.
They are made from china
I believe the 1990 year still had the sealed system. So there is no rad cap. You can add fluid by pourig it into the overflow bottle with the vehicle running the coolant will be sucked into the system. No radiator cap exist in the 90, 91 model. You add the coolant to the coolant container (The coolant container cap is the equivalent of the radiator cap, (pressure device))and the palstic container is under pressure all the time. Be carefull when you want to open it after the car has been running. After those year models, Jeep discontinued the use of the pressure container and went back to tha radiator cap and remove the pressure coolant container.
Low coolant? Radiator plugged or restricted? Water pump not circulating coolant? Hoses collapsing? Thermostat not opening?
It would be best to disconnect the coolant lines and flush the core after the radiator flush. This will clear any sediment from the core.
The windshield streaming after a radiator change on a 1993 Jeep Wrangler is a result of a loose connection. Steam is caused when coolant leaks onto the engine and is heated rapidly.
how to change radiator 1995 jeep grand Cherokee Laredo
Take the cap off the radiator and open the petcock on the bottom of the radiator.
Bottom of radiator.
If your 1998 Jeep Cherokee is leaking coolant, it might be a seal but it is more likely that it is a hose. This might also be a radiator leak, a loose hose clamp, or the freeze plugs in the radiator.
through the overflow bottle
Red, 5 year, HOAT type
The radiator drain plug should be located on the bottom of the radiator on the passenger side. Open that, let the old coolant flow into a drain pan, replace the drain plug once the coolant is out and the radiator is flushed, then fill it up through the radiator cap.
No, they will not clear the brake caliper.
It flows in the bottom hose of the radiator and out the top hose.
on a 1999 jeep grand cherokee where is the coolant fan relay
The bottle on the firewall with the radiator cap on it is where you add coolant.