0
Drain the anti freeze. Then take the air intake system off. Then move the coil to the side. On the drivers side of the engine you have to move the Power Steering line to the side. Now all you have to do is release the spring tension clamps that came from the factory. Use small pliers or small vise grips (my choice) to slide them down on the hose. Use a sharp knife (small) to cut the hoses away from the fittings. Pulling on the hoses is a NO NO. You will break a fitting & tear your hand up. Use the screw type clamps to put the new hoses back on. Some people say use an adhesive to put the hoses onto the fittings. I would just tighten them securely. If you use the adhesive and want to turn the hose around & it has already hardened, you are in trouble. . They don't use adhesive at the factory. Always clean the heater control valve ends. Clean the heater control valve with a spray like WD-40. Use the gray sand paper to clean all of the fittings where the hoses will be attached. Then use a clean cloth with a small amount of alcohol to get rid of the sand paper residue. I would replace the heater control valve. This is an old car. You can be sure that when you close the heater control valve that no hot water is passing through the system when you turn the heat & cool knob on the dash. All it takes is a stiff heater valve to let hot water keep your ac from working properly. Also you will not damage the cable. A worn out heater control valve can cause you to break your adjustment knob and your cable. Replace your anti freeze with the orange anti freeze. The green solution can ruin the radiator if it is made of aluminum. Check with your Honda dealer if its possible. Most dealerships will not give out information from the mechanic. Why do you think they are in business. The parts man is generally the only person you will be able to talk to. The service manager doesn't work on your car either. If they give you the information you won't be coming to see their mechanic. I run the Dexcool(pink) in mine with distilled water. You shouldn't use regular tap or well water because of the minerals. Check for leaks after you crank your car up. Check again after you drive it around the block a few times. Keep an eye on your temperature gauge. Always use Honda parts if you can. That's why you bought a Honda in the first place. Right!!! You can't beat Honda parts. Buy them online from Majestic Honda.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do fix Water leak on driver side of engine next to firewall 1992 Honda accord?
replace your heater hoses going into and out of the heater core. One of them is probably split.
A engine diagram for a 1991 2.2 Honda Accord for the coolant hoses?
A Ignition coil diagram for 1991 2.2 Honda accord
Why won't my 1990 Honda Accord idle?
check the vacuum hoses
What would cause a 1991 Honda Accord LX to overheat while only blowing out cold air from the heater?
Hose going from engine to heater core may have burst. Check all your coolant hoses for leaks.
How do you change the heater hoses on a 1993 Chevy Lumina?
how do you change the heater hoses on 1993 chey lumina 3.8 liter
When should you change hoses on 2004 Honda Accord?
Well I have a 2004 Accord V6 with 95,000 miles on it and the hoses still seem to be good. I will change them when they become soft or cracked. So far so good. So inspect yours and if they look and feel good then leave them alone.
Where is the heater inlet hose on 95 Honda Accord?
It is located at the back of the firewall behind the motor and it run under the distributor into the block. You actually have two hoses back there but it's the one running to the engine block.
How do you change the heater hoses on a 1999 z28 camaro?
The 1999 Chevrolet Camaro heater hoses will have a swivel nut on each end of the hose. Turn the swivel nuts to the left and the heater hoses will come off. Reverse the process to install the new heater hoses.
Where is the vacuum hose located on the automatic transmission for 2002 Honda accord LX 4-cylinder?
No vacuum hoses on newer Honda transmissions.
Where is the starter in a 1986 Honda Accord?
1986 Honda Accord starter is located on the passenger's side, on top of the transmission, under several cooling system hoses. Follow the positive cable from the battery and it will lead you to the starter. Drew
Where is the Vacuum hose located on a 1996 Honda accord?
There are numerous vacuum hoses at various locations on the engine and under the dash.
How do you unclog a 95 accord lx heater core?
The hoses to the heater core can be disconnected under the hood. connect a water hose to the core, and try to flush the core to unclog it.
