Want this question answered?
There is a screw on the side of the signal, you can reach it through the middle of the bumper. unscrew that and the whole signal will come out of the bumper. pop the clips and then the lens will come off
you push in front of lens into bumper, and than slide lens into bumper and it will pop out, then change bulb by pulling socket out.
The lens is only available as the whole fog lamp. You have to remove the bumper to replace it.
It is mounted to the drivers side taillight lens inside the trunk. It simply unplugs from the lens.
Remove the bulb from the back side. The lense does not have to be removed.
Is this the side marker or is it in the bumper, to replace the light in the bumper, you need a Philips screw driver, and on the inside side of the light, there is a little hole in the bumper, stick it in and loosen the screw. After that the lens should come right out and you just need to twist the fixture and the bulb will come out the back. after that the bulb can be pulled out of the connector and tah dah... Is this the side marker or is it in the bumper, to replace the light in the bumper, you need a Philips screw driver, and on the inside side of the light, there is a little hole in the bumper, stick it in and loosen the screw. After that the lens should come right out and you just need to twist the fixture and the bulb will come out the back. after that the bulb can be pulled out of the connector and tah dah...
Open lift gate Notice what appears to be a small, round rubber "bumper" on the inside of the vehicle opposite the tail light lens. Carefully pry the rubber "bumper" out. This will loosen the tail light lens so you can now pull the lens assembly away. Replace the defective bulb. Replace lens assembly. Re-install the rubber "bumper".
you need to remove the bumper to access the 2 10mm bolts of the headlight
Answer : unscrew the signal lens and remove the signal bulb and replace with 1157 bulb reverse process
Resubmit question including make, model and year of vehicle.
You will have to remove the lens either the front or rear. you did not say which.
Hey Melissa==You can remove the bulb fronm the rear of the light and replace it. GoodluckJoe For Melissa and others: I will describe this as a left side change. Reverse left/right directions for the other side. Use a Philips head screw driver to remove the turn signal housing/lens assembly. The screw remains captive in the housing. The screw is hard to see. Your screwdriver will fit in a hole in the bumper cover, just to the left of the orange signal lens, at an angle, pointing toward the left front wheel. After a few turns, gently pry the lens from the left end outward toward the right. If it doesn't come nicely, turn the screw some more. Once the housing is out, you can easily turn the bulb holder 1/4 turn to remove it and subsequently the bulb. I'd add that the right side of the lens housing (for the left side change described above) is held in only by a tab--so sliding the lens from right to left as you pry on the left side should pop the whole housing out.