answersLogoWhite

0


Best Answer

Disconnect the fluid lines to the slave cylinder. Remove transmission(refer to hanes manual), the clutch will stay on the motor pull the trans off so input shaft is out of clutch then pull out the slave cylinder. Put trans back in. Attach lines. Will have to bleed it, just like bleeding breaks.

User Avatar

Wiki User

โˆ™ 2008-04-05 00:45:32
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the slave cylinder on a 98 Sunfire?
Write your answer...
Submit
Sign up for more answers

Registered users can ask questions, leave comments, and earn points for submitting new answers.

Already have an account? Log in

Related questions

How to replace ignition key cylinder for 1996 Pontiac sunfire and recheck theft deterent and code new key cylinder to vehicle?

how to remove key cylinder on 98 sunfire


How much cylinder compression should a 2.2L 98 Pontiac sunfire have?

150psi


How do you fix a broken concentric slave cylinder bleed valve on a 98 gmc sonoma?

Replace the slave cylinder.


Does a 98 mustang GT have a slave cylinder?

no , cable operated clutch


Where is the concentric slave cylinder on a 98 Ford Fiesta?

it is inside the bell housing


Where is the slave cylinder located on a 98 3000gt sl?

Slave cylinder on a 5 speed manual transmission is found standing by the passenger fender looking below the air flow tube.


Where is the clutch slave cylinder on a 98 Isuzu Amigo located?

The clutch slave cylinder is attached to the middle of the transmission towards the passenger side. It is easy to see by looking under the car at the passenger side door.


How to replace clutch slave cylinder 1991 Nissan Maxima?

I am paying $195 parts and labor in my 98 maxima


Were is the slave cylinder on a 98 s-10?

It would be found in front of the transmission, inside the bell housing.


How can you change rear drum brakes to disc on a 98 Chevy Tahoe or what SUV will fit on 98 Tahoe?

You have to change the whole rearend and the master cylinder.


Is the hood from a 98 pontiac sunfire gt compatible with the hood of a 99 pontiac sunfire coupe?

Yes!


What is the proper freon type for a 98 Sunfire?

R134a


Will a Standard Transmission From a 98' Sunfire 2.4L fit my 98' Sunfire 2.2L standard transmission?

yes gm makes all bell housings the same


What is the gas tank capacity of a 1998 Pontiac Sunfire?

the 98 sunfire haz a 57.2 litre gas tank


How do you change the ignition cylinder on a 1987 Olds 98?

you will need to pull the steering wheel and column cover then it will be simpl to pull out cylinder and replace it.


How many miles per gallon does a 1997 Pontiac sunfire get in city?

I have a 98 sunfire with the 2.4L and it is getting about 35m/gal on the hwy.


What size alternator amps is in a 98 sunfire gt?

105 amps


Where is the paintcode on a 98 Pontiac Sunfire?

usually on the driver side door


Where is the turn signal switch for a 98 Pontiac sunfire?

under the dash


What are the differences between a 98 Pontiac Sunfire GT and an SE?

Something...


What color wire goes where on the starter of a 98 Pontiac sunfire?

On a 98 Pontiac Sunfire, the red color of wire goes on the terminal marked "B" on the starter. This terminal is located close to the battery of the vehicle.


How do you replace internal slave cylinder on 98 Chevy s-10?

You will need to remove the transmission and you will find it in the bellhouseing. There will be 4 10mm bolts that hold it on,


Where is the slave cylinder on a 98 escort?

It is on the front of the bell housing of the transmission. To find it trace a "brake line" fitting from the firewall to the bottom of the transmission bell housing.


How many horsepower on a 98 Sunfire GT?

This should help you out; http://consumerguideauto.howstuffworks.com/1995-to-2005-pontiac-sunfire-6.htm FriPilot


What size engine does the 98 Sunfire have?

Have a look at this web site; http://consumerguideauto.howstuffworks.com/1995-to-2005-pontiac-sunfire-6.htm FriPilot