Use a 12 Volt test light 2 make sure U have 12 volts & a good ground @ the motor connection-IF u do, the motor(if good) will run.IF no runnie then down 2 your local parts store U go.
The windshield washer motor is located on the passenger side firewall
It should be inside the windshield washer fluid tank
Wiper arms cannot be repaired, only replaced. The arm should come off by removing the nut at the bottom of the arm and the washer sprayer hose
The reservoir for the windshield washer fluid is low.
It depends on the vehicle but in many vehicles the washer pump is attached to the washer reservoir. If yours is not the case please give us more info on the vehicle and repost.
Most of the later GM washer pumps are located at the botoom of the washer fluid container. You will need to remove the tank to get access to the pump.
i have a problem with the washer pump when i put a voltage tester on the connection it jumps all around from 5 volts to 10
200-250$
Do you mean "how do I replace washer line"? They are just rubber hose from the washer fluid container to the wipers. If you have a leak, you can get a plastic splice and put it in at the split to repair.
Begin by removing the hose from your windshield washer pump. Remove the windshield washer pump wiring harness. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer pump.
The nozzles pop in and out easily if you twist and slide them around.
More information please. Which part of the system. The wipers? The wiper arms? The linkage conecting the wiper arms to the motor? The motor? The windshield washers? Windshield washer pump? Etc? Please be more specific.
Remove the wiring harness from the back of your Chevy Lumina windshield washer pump. Remove the windshield washer pump fluid hose. Remove the windshield washer pump retaining bolts. Reverse the process to install the new windshield washer pump.
The windshield washer pump is located on the firewall in the engine compartment. Remove the windshield washer pump hose. Remove the wiring harness. Remove the windshield washer pump retaining screws. Reverse the process to install the new windshield washer pump.
The windshield washer motor is located on the passenger side firewall
Remove the wiring harness from your Volvo windshield washer pump. Remove the windshield washer pump fluid hose. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer pump.
There seems to be none. Neither the Owner's Manual or the Haynes Repair Manual show a fuse for the Windshield Washer Pump...