answersLogoWhite
2000-2005 Dodge & Plymouth Neons
Mazda Tribute
Chevy Beretta
Ford Escape XLT

How do you get to your fog lamps to replace?

181920

Top Answer
User Avatar
Wiki User
2006-12-15 00:08:58
2006-12-15 00:08:58

alright these are fun.....you have to take off the plastic covers underneath. There should be two torx bolts that are holding in the assembly that you get to from the front. after this reach up from underneath and push out the assembly through the fender. you wont have much room to work on it but its just enough to replace it. Test before putting back together because its a pain trying to get them out. the bulb will have one wire coming from it with a metal slab at the end of it. the slab will slide into what looks like a splice connection. there is a gound wire that will go to the metal flanged washer on the back of the fog light assembly. make sure this is clean and gets a good connection, i had to wiggle mine to get a good connection so it would work. good luck!

1

Related Questions

User Avatar

Fog lamps on a car show up a lot more in the fog than other lamps simple because they are much brighter. It is therefore advised that you only use them in extreme cases of fog as it can cause issues for other drivers if you have your fog lights on when there is little to no fog.

User Avatar

look under the vehicke where the fog lamps are and you will see a rubber housing that fits around the openin gof the fog lamps, Now take off the rubber seal and you will see the mini bulb and alls you have to do is push forward on both of the small springs and it will release and from there you can tak eoff the mini fog lamp bulb.

User Avatar

There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose. Untrue...in the 2008 Liberty in any case.

User Avatar

Go to www.stores.ebay.com/blinglightsracing or www.blinglights.net I have an 05 Ram and I purchased their kit, and had it installed within an hour. There fog lamps are twice as bright as factory fog lamps. I highly recommend them!

User Avatar

On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam

User Avatar

I have been reading many websites. they all say that to replace the fog lights on this vehicle you have to remove the front bumper. This is true only to the extent of the passenger side of the vehicle. If you are attempting to replace the fog lamps on the driver's side, you can simply remove the air filtration box to perform the operation as it will give you enough room. However, on the passenger side of the vehicle (at least on the 6s version of the vehicle) you will be unable to reach the quick-disconnect socket which is buried too low in the engine compartment to reach any other way. The best thing to do for the fog lamps is to take the vehicle to a Mazda dealership and have them replace the fog lamp for you.

User Avatar

Replacing a fog lamp on 1997 Olds LSS is easy. All you have to do is take the lights out of the car, take the old bulb out than replace it with the new one.

User Avatar

Take a look here, if your Ford is a MK2. http://www.fordmondeo.org/wiki/index.php/Fog_Lights_-_Mk2

User Avatar

it will still pass inspection but it is better to buy the fog lamps

User Avatar

The fuse for the fog lamps on a 95 Nissan Pathfinder are located in the main fuse panel. This can be found near the hood release on the driver's side.

User Avatar

According to the 2001 Ford F-150 Owner Guide : The Fog Lamps take bulb ( # 9145 )

User Avatar

pull the headlamp control towards you to turn your fog lamps on

User Avatar

If it has fog lights, you turn the headlights on and pull the switch out.

User Avatar

Yes, having fog lamps on - either front or rear - when the visibility is good is a motoring offence in the UK and can result in a fine and points on the license.

User Avatar

Pull the end of the turn signal lever out about 1/8th inch. This only works with the lights on. Fog lamps will not work with headlights off.

User Avatar

The rotary dial for the lights pulls out to turn on the fog lamps.

User Avatar

The fog lamps are located in back of the head lights. To replace bulb, lift hood, reach to the rear of head lights, remove cover, and unplug brown wire. A brace clip holds the bulb in place. Push clip to release and remove bulb. After replacing bulb return components and cap.

User Avatar

go to the store buy yourself some h3 bulbs then grab yourself a star screwdriver and take the two screws out from the front

User Avatar

Check the fog light switch and the wiring. Also check the ground wires. There is a power loss somewhere in the system.

User Avatar

how to replace a front fog light on a ford focus

User Avatar

how to replace a fog light on a Jaguar?

User Avatar

How do I replace the fog lights in my 03 mercury mountaineer

User Avatar

If there are already lamps there you can as you say plug and play. I suggest when you expose the wires you seal with a genorous amount of electrical tape or a shrink tube.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.