answersLogoWhite
Ask
Heating AC and Engine Cooling
Heater Cores and Blower Fans
Ford Expedition Eddie Bauer
Ford Expedition XLT

How do you install a blower motor on a 1995 Ford Thunderbird?

858687
Answer

Top Answer
User Avatar
Wiki User
2010-02-24 18:51:07
2010-02-24 18:51:07

It will be in the firewall on the far right of the engine compartment, just below the hood. four screws, and a couple of wires holds it in. The blower (squirrel cage) then has to be removed, and transferred to the new motor. Then replace. It isn't that difficult.

Afraid it isn't QUITE that simple, on my 1995 Thunderbird LX it is way down on the firewall on the right side, near the bottom.

1
0

Related Questions

User Avatar

Remove the wiring harness from the back of your 1995 Oldsmobile Aurora blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.

User Avatar

Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.

User Avatar

it should be next to the blower motor

User Avatar

fuse, wiring, blower motor, blower motor switch, blower motor resistor

User Avatar

Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.