4 questions on Crown Vic, assume same person. If you can get the fuel pump out of the front of the gas tank with the tank in place that saves a lot of work. Make sure the tank is close to empty or have a large bucket ready. Sparks, heat sources have to be looked at before you start. The fumes can travel a long ways. As far as the fittings or hoses go. If they look like they "plug in" to a one inch round, quarter inch thick washer or ring on the line, you will need the release "tool" for that. Plastic ring that goes around the line and then you push it into the fitting to release it and pull the line out. A whole set is not very expensive. After that, it's fairly straight foward. LOcking ring on pump housing, a couple of wires, and pull it out and reverse the process.
In the fuel tank.
It's in the fuel tank.
A 1997 Ford Crown Victoria engine is fuel injected so there is no carburetor
Located under the vehicle, in front of the fuel tank.
Yes ( its electric )
The fuel lines on your 1987 Ford Crown Victoria are held in place with a swivel nut on each end of the fuel line. Loosen the swivel nut to remove the fuel line. Reverse the process to install the new fuel line.
A flat head screwdriver.
on fuel tank next 2 sending unit
If you are talking about the fuel pump reset switch, they are usually in the trunk.
The fuel tank holds 20 gallons ( according to the owners manual ) U.S.
ford fuel line disconnect tool. available at your local auto parts store.
where is the fuel pump relay located on a 1987 ford ltd crown Victoria