Want this question answered?
Remove the long access panel from the inside of the tailgate.Unhook the two metal rods from the handle on the inside of the tailgate.Remove the two bolts from the door handle located on the inside of the tailgate.
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
Chances are that your tailgate doesn't keep opening, rather it isn't latching properly. I had a '97 with a similar issue. You need to remove the tailgate handle bezel, and you may be able to lubricate the handle mechanism from that point. Use a white lithium spray grease, or a graphite lubricant. If not, you will need to remove the mechanism from the tailgate.
How do I take off the handle to put a new one on a chevy colorado 2005
If you look where the handle goes you will see 2 rods. Just squezz them together. Are use a screewdriver to pry them towards each other.
You first must take off the handle to see what your problem is. Most likely it is one of the plastic pieces that holds the release rods to the handle. To take the handle off there are three 14mm bolts on the inside of the tailgate.
When you pull the handle the left side catch disengages, but the right side does not. Looking at the handle, when it is pulled it catches and pulls a piece of metal towards you, disengaging the tailgate lock on the left side. However the lever or whatever it is on the right side does not come towards you when the handle is pulled and does not disengage on the right side, preventing getting tailgate open or down
Most often the cause is two broken clips inside the tail gate mechanism. By pushing upwards you can remove the plastic bezel around the tailgate handle; its just snapped into place. You should now be able to see the mechanism under the handle. There are two metal bars coming in from the sides of the tailgate. These operate the latches on either side of the tailgate. They are attached to the central tailgate handle mechanism by plastic clips. One is pink and one is green; colored to indicate whether they go on the right or the left. You can get these clips from a dealership for about 5 bucks a piece. Hope that helps.
I had to take my latch apart and lube it up really good.
I would use an epoxy.
Year, make and model would help.
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.