How do you perform an oil change on a 2000 Pontiac grand am V6?

Answer 1

Raise the vehicle safely. Remove the drain plug in the oil pan, should be a 15mm. Let oil drain and replace plug. Do not over-tighten it. Remove the plastic cover under the radiator (the one with two wing nuts holding it in.). It will be necessary to remove the oil filter. Use a band wrench to loosen the filter and remove. Lube the O-ring on the new filter with a drop or two of clean oil and replace, making sure that the O-ring from the old filter is not still stuck to the engine block. Screw the filter on hand tight. Lower the vehicle and fill the oil with about 4 1/2 quarts with the 3400 V6. Check the dipstick and make sure there is oil in the crankcase. Start the engine and make sure the oil pressure light turns off after a few seconds. Check dipstick again and make sure level is full. You're all set.