This worked on a Mazda MPV
1. Open Drivers door and leave open.
2. Lock and unlock the drivers door using the power lock switch on door panel.
(not sure if this is required)
3. Insert key into the ignition.
4. Turn key to the ON and OFF position 3 times in 10 seconds. Leave key in ignition. ( i have seen others say 24 seconds for 4 & 5 combined)
5. Open and close drivers door 3 times ending with door in the open position.
(you can depress the door switch instead)
6. Door locks should respond by locking and unlocking.
7. Press any button on remote 2 times. Doors should lock and unlock.
8. If programming a second remote press any button 2 times on it and door locks should cycle again.
9. Remove key from ignition and door locks will cycle again.
10. Test remotes.
There should a programming guide in the users manual
On the inside of the keyless entry remote or sometimes on the back it explains how to do this. I believe you hold the unlock button along with the lock button for 7 seconds near the car. It will explain it on the inside of the keyless entry remote.
25 - 50 bucks at the dealer
The keyless module is under the dash on the driver side. Do a search for Subaru Keyless Entry System H7110FS300
The keyless entry module on a1998 Honda Accord is located underneath the dashboard. It is housed on the driver-side the of dash close to the main relay.
The location of the remote keyless entry module on a 1998 Saturn is in the rear of the passenger compartment. It is underneath the trim at about shoulder height by the right rear seat.
It can have power locks with out keyless.
the dealer does it with a scan tool
Open the trunk and it will be on the trunk lid hinge
I have a 1998 and the code is in the back where your jack and accessories are.
Keyless entry codes for most makes and models can be obtained from a dealership with the VIN number and identification. If the code has been changed by a third party then the dealership will not be able to retrieve it.?æ
It seems like the 1998 grand marquis key-less entry model was the only model made where u would actually have to take to a dealership to have it program there as it requires a computer module to program it.. unlike the rest of all models where u would be able to program you're self.. with the key and keyless entry pin pad those procedures just wold not work on the 98 model.. have tried it out... and it not work..