answersLogoWhite

0


Best Answer

It depends what the reason conditions are for the refilling. In all cases be sure that the engine has cooled down completely, before working on the cooling system. If you are just topping it up because the coolant overflow tank level has dropped completely with nothing left in it. Then you might want to remove the rad cap, and fill up the rad to the bottom of the filler neck. Replace the rad cap and fill the overflow tank. ++++++++++++++++ But if the level rizes up into the overflow tank when the engine is warmed up, you simply add the proper coolant directly to the tank. +++++++++++++++++++ If the coolant system has been flushed and cleaned, then use something like this procedure. With the radiator cap removed and the engine cooled down (the cap is on the passenger side of the rad), after making sure that the engine has cooled. Pour the proper coolant into this opening, until it reaches the bottom of the filler neck. Wait to see if the coolant level drops (it will, if you are starting with an empty radiator, because it gets air locked). This will happen within a minute or two. Continue adding coolant until its level doesn't drop anymore. Run the engine with out the rad cap on for a very short time (a couple of minutes at the most ), then shut it off and top up the level again. Now it is time to put the rad cap back on, and only partially fill the plastic overflow tank ( a little more than half full ). Run the engine and let it get up to operating temperature. Shut off the engine and let it cool off considerably(half an hour or more), and notice that the coolant level in the overflow tank changes up, then down, with in the time between when you started to let the engine begin warming up to operating temperature, and then letting it cool down. After it has cooled down, add coolant only to the overflow tank, providing it hasn't gone down until it is completely empty. You could stand by and watch that the level in the tank so that it doesn't drain out completely. If it looks as though it might happen, just add more coolant before it does happen. If the coolant level rizes and falls in the tank with out going empty or becoming drastically overfull, your finished

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you refill the cooling system with antifreeze On a 1999 Pontiac transport?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the cooling system refill procedure for a 1988 Buick Regal?

A 50/50 mixture of antifreeze and distilled water.


What is the procedure for refilling antifreeze after fixing a leak?

I assume you are referring to a fixed leak in the cooling system. In that case, add a solution of 50% antifreeze and 50% water to refill the system.


What is the cooling system refill procedure for a 1991 Olds?

you should mix antifreeze half and half with clean water and fill radiator to full, then add to cold line in the overflow tank


Where do you refill antifreeze in a Lincoln LS?

At the radiator or at the coolant resivoir.


What is the GM approved procedure for draining and filling the entire cooling system radiator and block for a 98 Pontiac Transport?

Hey Nancy==Simply remove the drain plugs from each side of the block and the bottom of the radiator. CAtch the old coolant and dispose of it properly. Refill the system with 50/50 mix of coolant and water. GoodluckJoe


What to do if radiator is exposed to diesel fuel?

You can drain the cooling system then refill with clean water and a cup of "Lestoil" household cleaner. Run the engine for several hours then drain the system and repeat the process until the drain water runs clean. Refill with a mixture of 50% water and 50% antifreeze and you will be fine.


How do you change antifreeze in a Mercedes?

To change the antifreeze on a Mercedes, locate the drain plug on the bottom of the radiator. Drain the fluid into a pan and refill it.


What happens if you put antifreeze in the crankcase?

vehicle will overheat. just dump the oil and antifreeze , flush engine and refill with clean oil


What else can you look for if you replaced the thermo switch but its still not kicking in to stop the overheating?

if you change your thermostat and refill your car with antifreeze/coolant you may have air in your cooling system causing hot spots. you should bleed the cooling system let the air come out. it can also be an internally collapse hose.


What does service code A15 on a 2008 Acura TL mean?

A - Oil & Filter Change, Lubricate locks, check tire pressure, top off fluids1 - Tire Rotation5 - Pressure test cooling system, check for leaks. Drain antifreeze and overflow bottle, refill engine cooling system


What should you do if you pour antifreeze in the power steering reservoir?

Do not run the engine. You need to drain out the fluid antifreeze mixture.You can then refill the power steering fluid.


How much antifreeze does a 1992 4.3 V6 s10 need?

A 50/50 mix of antifreeze and water is the standard. That protects the vehicle to aprox minus 34 degrees F. If the cooling system was completely drained, including the radiator, engine block and heater, the system would take aprox 11 to 12 qts to refill.