if you look around the headlight, there are silver clips that hold the clear cover of the headlight piece, i think there are two on the top and two underneath between the bottom of the headlight and the front bumper. release the clips and the lens comes off, then giving you access to the screws holding up the bumper to get it off. it's easier to use needle nose pliers or something to grip the clips while unscrewing the screws holding up the bumper sides to both front fenders located at the top corners of the bumper on either side in the wheel well. As for the entire headlight assembly, there are screws from the back and outer sides of thepieces to unscrew. Don't forget to unscrew the bulb from the back of the headlights and remove the corner lamps(one screw on each side visible from overhead)by sliding them forward. Previous answer is wrong. The headlights on 1994-1997 Accords are sealed units, and do NOT come apart. To remove the front bumper and headlights: Use Phillips screwdriver to remove five screws from the grille, four on top, and one is hidden down lower, near the hood latch. Remove one screw each from the corner lights as described above. Gently pry them forward to unfasten the pegs from their holes in the fenders. Twist to unscrew the bulb sockets. Unfasten the black plastic rivets that attach the bumper cover to the rubber wheelhouses underneath, on both sides. At the upper rear corners of the bumper cover, remove one screw from each side that attaches the bumper cover to each fender. Using a Phillips screwdriver, reach in through the air intake grille in the bumper, at an angle, and remove one screw per side that holds in the turn signal lens and housings. Remove and unplug these. Using a long extension and a 12 MM socket, reach through the openings where the turn signals were, and loosen the bolts that hold the bumper structure to the radiator support frame. The bumper is slotted, gently lift it off of the top two bolts. The headlights are now removeable with a 10 MM socket, bolted through the top, each side, and lower front corner toward the center of the vehicle (not from the back as incorrectly stated above). The lower headlight bolts are NOT accessible with the bumper and cover still installed on the car. The plastic rivets that attach the cover to the bumper structure can now be easily accessed without ruining the headlights.
This video on YouTube (see Related Links) will show you how to remove the front bumper cover from of a 2004-2007 Honda Accord.
remove the bumper, you will then see the bracket that holds the bottom of the light to the car. the rest is pretty self explanitory once the bumper cover is off
Front? Rear?
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
No.
you need to remove the bumper to access the 2 10mm bolts of the headlight
This just isn't something that you want to do. Remove engine shroud, grill, bumper on the side that you're working on, inner fender fasteners - then you can get to the 4 bolts that hold the headlight assembly in. Did it yesterday - won't do it again. 5 hours :-(
take a baseball bat and smash the light with it.
yes
you have to remove the screws from the top of your bumper and remove the screws from the front of the wheel well bumper should slide forward then remove two bolts on top of headlight then remove bolt under headlight then housing should come right out
first remove the bumper turn lights...two screws on one each light..then remove the lights carefully, so you do not break them.... After that...remove the bumper screws in the wheel wells.... Then, where you have removed the bumper lights...with a socket extension..and a 12 mm socket...remove two bolts on each bumper mounts.....then the bumper should come off in a forward direction.... you now have access to both headlight assemblys.
The headlight is an assembly. To replace the headlight, you remove the bulb from the back side. It is a halogen bulb, so do not touch with bare hards before installing.