There are three T-25 head screws along the bottom of the inside door panel. Remove them. The face of the inside door handle is removable--just pry it off, probably don't even need a screwdriver to get it off. Underneath, you'll find two #1 Phillips head screws. Remove them. Finally, grasp the door panel from the bottom and pull up. It hangs over a little lip against the window. Watch the door lock, make sure the panel clears that. You should have access to all the wiring harnesses that keep the panel attached
How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?
Go to this website. It will show how to remove the door panel.
Clips hold the door panel in place. To remove the panel, you will need a small pry bar and apply gentle pressure to the gap between the panel and the inner part of the door.
You can replace the inside drivers door handle by removing the door panel. With the door panel removed the door handle mechanism will be visible. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Magic
Remove the screw under the door latch
Using a screw driver, remove the screws and remove the clips from the door panel. Remove the panel slowly, remove any wire connections, and pull the panel off the door frame.
You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
Yes.
just remove it
Remove the rear door panel.