shoud be a Philips screw on the side of the rotor. remove carefully using a quality screwdriver.
sometimes the rotor sticks on. get a hammer and metal or wood bar/stick tap at the top behind the rotor to get it to move. it might take a minute but keep at it and it will eventually move . I had to tap mine all the way off the distro.
Or squirt some penetrating lube in the screw hole, wait a few minutes and try to twist it. When it breaks loose it will be easy to get off.
To change the distributor rotor on a1998 Honda Civic unplug the spark plug wires from the cap. Loosen the screws and remove the cap on the unit. Be sure to properly line the new cap on the distributor and install.
MSD w/ a rev limitor.
Inside the distributor cap under the rotor
Firing order is 1-3-4-2 Rotor turns clockwise.
a little 8 mill screw on bottom of rotor into dist shaft
Begin by removing the tire and wheel from your 1993 Honda Civic. Remove the brake assembly and the brake rotor. Remove the axle retaining bolts. The axle will come off.
Loosen the screws on the cap and there is a single screw holding the rotor to the shaft
how do you remove a distributor rotor on a 92 Nissan sentra
Try the main relay. Mine was behind the glovebox on a 1996 civic. Good luck.
The coil is located in the distributor internally. If you take the distributor cap off and unscrew the rotor it should become visible. You may have to move a dust cover, but it is in there.
To change the brake rotors on a 1991 Honda Civic raise the vehicle. Remove the wheels and brake caliper bracket. Remove the brake pads. Loosen the rotor mounting screws and replace the rotors.
It is located under your distributor cap, behind the rotor. There are two bolts on the side of the distributor that must be loosened, take off the three wires, and it will come right out.