disconnect neg.cable,then disconnect pos. cable from starter ,then other wire,then remove 2 bolts holding starter to engine.
remove neg.cable.then positive cable cable from starter,remove male to female wire ,then remove 2 bolts holding starter to engine.
go to auto zone.com and enter your vehicle year,make and engine size,then go to repair after looking up starter,it will tell and show how to remove and replace.
disconnect neg. battery cable ,remove pos.cable from starter .10 or 12 mm wrench.remove wire from starter ,no wrench needed,its a male to female connector,remove 2 bolts holding starter to engine,12 or 14 mm wrench,thats it.
Remove the positive battery cable from your 2001 Nissan battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
go to auto zone.com enter vehicle info.then look up starter,then click on repair guide and it will tell you.
disconnect your battery. disconnect the cable(s) on the starter. remove bolts from starter. pull starter out from bellhousing. enjoy life as you know it. eat crackers and tacos.
remove negative battery cable,jack up truck and remove front passenger tire,easier to get to,its next to oil filter,remove ignition wire from starter,remove positive battery cable from starter,remove 2 bolts holding starter on to engine,remove starter,installation is same as installing.g0ood luck.
Remove the positive cable from your 1995 Nissan Pathfinder battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
must remove oil filter to get starter out have fun
First remove the negative battery cable from battery. Then get under truck and remove the wires from the starter solenoid, making sure to mark them to which terminal each goes to. Then remove the two bolts holding the starter and then lift out the starter and solenoid. That is how hard it is.