Want this question answered?
Most cars have a switch to disable the cruise control. To permanently disable the cruise, remove the fuse for the circuit.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
The alarm module is located between rear of engine and firewall. A specialized wrench is needed to detach and remove.
how do you remove the ignition control module on a 1988 ford f-250 pickup?
The control module is located under the air cleaner box. Carefully remove the the upper air cleaner enclosure, MAF sensor and rubber duct. Remove air cleaner and lift compartment lid. Computer control module is there. Hope this helps?
remove the body control module
The ignition module is integral to the distributor and is not serviced as as separate part.
Under the hood you will see 2 cables comming from the throttle body. one is the foot pedal the other leads to the cruise control module. That is it! The cruise control unit is located inside the left front fender. You have to remove the wheel and wheel well liner to access it.
Check your Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
Remove the battery and the cruise control actuator. The starter has two bolts holding it in. Remove the bolts and wiring, then install the new starter. Re-install the cruise control and battery.