you dont need to remove hub just remove the caliper and spider washers on studs
In the distributor, under the rotor.In the distributor, under the rotor.
On my '90, the rotors are held in place by the wheel studs. I had to press the wheel studs out, then the rotor separated from the hub.
How to remove bed rails from a dodge truck
You need to remove the head lap it has some scews on the side and on front.
The front axle itself does not need to be removed.
You slowly remove it
You will need to remove the tire and wheel from your 1995 Chevy Cheyenne. Remove the brake assembly. Tap on the rotor with a hammer or mallet. The brake rotor will slide off. Reverse the process to install the new brake rotor.
1 and 11/16 inch
If its a 96 you need to unbolt the center seat, Then there should be four bolts on the floor.
Remove wheel Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to full retract piston into caliper body Replace inner and outer pads Re-install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
You have to unbolt it from the frame that attaches to the hood of the truck.
Remove wheel Re-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" Clamp to fully retract piston into caliper body Replace inner and outer pads Re-Install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
On a Dodge truck, the vacuum switch is on the transfer case.On a Dodge truck, the vacuum switch is on the transfer case.
Front bearing will drop out when remove from spindle, rear one will need to remove the grease seal then the bearing will come out. To get the races out drive them out by using a long punch and reacing throu the rotor and drive them out from the back side of the race.
on top dead rotor should be pointing at #1
what model truck i think they are all straight axles in front, im not sure about the half tons though, if this is true you dont have half shafts
Easy 4 to 6 bolts.
REMOVE the assembly from the truck then knock the wheel astuds out then knock the hub off the rotor.
i would like to know how hard is it to change the front hubs on a dodge truck?
dodge truck beds bolt on from the bottom, you will need to remove the rear bumper assembly and the fuel filler neck from the side of the bed too. then just call a few friends to help lift.
The rotor is threaded right hand, turning clockwise will drive the bolt inward, this will push the rotor off the truck. On_mitch
Front passenger side
The Dodge Dakota pickup truck has CV joints on both front wheels. The pickup truck also has a driveshaft, as it is rear wheel drive.