There is a clip holding the handle. It is located in the center in the back of the handle. There is a tool to remove & install it; but you can use a flat screwdriver carefully. Good luck.
Remove the bad one and plug in the new one, they are located in the power distribution box under the hood.
remove the complete dashboard and then replace it
pry up the cover from the outside of the handle and remove the 7 mm screws front and back
Remove inner door panel for acess
Remove Door Panel. Peel Back Water Barrier. Unscrew latch. Remove two bolts holding the handle inner to the handle bezel(outer). Remove the Anti-Theft shield with force. Remove handle. Reverse Process
remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.
CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Relieve the fuel system pressure * Disconnect the negative battery cable * If necessary remove the air cleaner assembly * Remove the clips and detach the hoses from the fuel filter then remove the filter bracket nuts and lift the assembly out of the engine compartment
depends on what side driver side remove battery unplug light turn the black retainer and pull on bulb passenger do the same without removing the battery
== ==
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
Yes you need to remove the subframe to remove the gearbox on elantra. the motor must be supported at the top before u remove the subframe.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car