If you want to look for Crest coupons, I would recommend going to a warehouse store such as BJs or checking your local newspaper every Sunday for coupons. BJs is a warehouse club that sells many different products in bulk and depending on what you purchase, it can be cheaper to buy in a pack of four compared to just one item. They often have coupons monthly for different products of toothpaste including Crest. If you decide to check your local paper, try to look for coupons on Sunday since many manufacturers will often place coupons in your local paper. If those two suggestions are unsuccessful, I would try either the Crest website directly or doing a regular Google search. If you go to the Crest webpage, there may be weekly or monthly specials on certain types toothpaste. Using Google, you can find many different websites that will allow you to print online coupons that you can use in your local store such as Target or Walmart.
You don't want the air bag to blow up in your face, which is why you disconnect the battery before you try to take apart the steering wheel.
Disconnect battery. Remove air bag. Remove bolt holding steering wheel to column. Use a steering wheel puller to remove wheel from column.
PROPERLY remove air bag (if equipt), then remove nut holding steering wheel on and then use a steering wheel puller to remove it.
you don't because it's a federal offense to remove a steering wheel that has a stock air bag in it
You need to get a special tool, steering wheel puller. If you have it, disconnect the battery. Remove the steering wheel air bag (there are two screws holding it in place). Disconnect the bag harness. Remove the center steering wheel nut. Using the puller remove the steering wheel. Installation is reversed to removal.
This is for a 1995 F150 with air bag. YMMV Steering Wheel with Air Bag SPECIAL SERVICE TOOL(S) REQUIRED ³ Description ³ Tool Number ³ ³ Steering Wheel Puller ³ T77L-4220-B1 ³ Removal 1. Center front wheels (1007) to the straight-ahead position. 2. WARNING: THE BACKUP POWER SUPPLY MUST BE DISCHARGED BEFORE ANY AIR BAG COMPONENT IS SERVICED. Disconnect battery to starter relay cable (14300) for at least one minute to let the air bag backup power supply discharge. Refer to «Section 14-00». 3. Remove four air bag module retaining nuts from air bag module on back side of steering wheel (3600), and lift module away from steering wheel. 4. Disconnect air bag wire harness connector, and remove module from steering wheel. 5. Disconnect horn/speed control wire harness connector in steering wheel. 6. Remove steering wheel retaining bolt. 7. Install Steering Wheel Puller T77L-4220-B1 and remove steering wheel. Route contact assembly wire harnesses through steering wheel as steering wheel is lifted off shaft.
Remove the air bag on the steering wheel. Your problem is in there......
Disconnect battery (very important!!!) There are bolts/screws that hold air bag to steering wheel. They screw into rear of steering wheel. Just unbolt, remove and disconnect electric conector.
Its a tough job that requires special tools. Remove the air bag. Remove the steering with a steering wheel puller. Remove the air bag position sensor. The steering wheel lock plate needs to be removed with a steering wheel lock plate puller. Then the turn signal switch can be removed by snaking the wire harness through the steering column. Not as easy as it sounds.
Remove the two screws on the rear of the steering wheel. It then requires a special tool to depress some spring loaded clips on either side of each air bag retaining screw, on the back of the steering wheel. It sucks.
Remove the steering wheel and disassemble the wheel lock mechanism. This requires removal of the air bag and some special tools.
you will have take the air bag off if equipp the steering wheel turn signal switch and lock plate
air bag has to be disconnected and taken out of the steering wheel and then the nut that holds the wheel on has to be taken off and a wheel puller is used to pull the wheel off it's splines.