Want this question answered?
well either your heater core is bad or your outer window door seal is leaking . i had the same problem on my Monte Carlo and i had to remove 1 of the studs that hold on the weather striping on the lower part of the door so it could drain .
How do you pull the wheel bearing assembly out from hub far enough to squeeze new lug nuts into place? The car is a 1999 Monte Carlo Z34.
1. Jack up the front end, and place it on jack stands. Always place it on jack stands. 2. Remove the lug nuts using a breaker bar/impact wrench 3. Pull the rim off the wheel studs To put it back on- 1. Align the wheel studs with the holes in the rim 2. Lift and place the rim on the wheel studs 3. Put the lug nuts back on and turn 2-3 times 4. Tighten using a torque stick/ torque wrech in a star pattern 5. Place jack under it and remove jackstands 6. Lower
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
you need to remove the front calipers then remove two Phillips head countersunk screws that are in the middle of the wheel studs
do you want to remove the actual studs or remove the lug nuts? the lug nuts may have left hand thread which means they go clockwise to loosen if you mean remove actual studs, u need to remove wheel. the studs will knock out with a hammer. you will need to replace with new ones
Lug studs on a 1994 Acura Integra is pressed into the hub. To remove the lug studs safely raise and prop the car. Remove the wheel, brake components, and suspension parts from the hub. Press out the old studs.
Remove the brake drum, drive out he damaged studs from the front of the drum, press in the new ones from the back of the drum, reinstall the drum.
t40
www.honda-tech.com yw.
wheel studs? head studs?