remove the rotor bolts(philips). do not strip them. take off caliper bolts 12mm and caliper carrier 14mm. you can remove also the metal plate on the arm for more room
Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra.
See http://www.ehow.com/how_4506404_replace-rotor-acura-integra.html
You'll need to remove the wheel, the brake pads and the caliper. Once all of that is out of the way, there are rotor retaining screws that need to be removed, either on the studs, or on the axle itself.
Should be "peel off" after removing brake caliper, unless it is rusted to center hub. Then try WD-40 or similar product to remove rust or corrosion.
Clockwise.
How do I remove the front rotors so I can replace the CV joints? .... After removing the brake pads and caliper assembly, of course.
That measurement is stamped on the rotor.
Hello, Removing the front rotors on an Acura TL is clockwork. Here is a quick how-to guide: 1. Raise and safely support the vehicle. 2. Remove the front wheels. 3. Remove the brake hose mounting bracket. 4. Remove the brake caliper bracket mounting bolts, and remove the caliper assembly from the knuckle. 5. Remove the rotor retaining screws. 6. Remove the brake rotor by pulling it straight off the wheel mounting studs or if seized in place, remove the stubborn brake rotor by threading in two 8 x 1.25mm bolts, two turns at a time until the brake rotor is released. Good luck with your brake job!
1-3-4-2 Rotor turns clockwise.
2005 Toyota tacoma how to remove the brake rotor
Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
After the tires and calipers are off take a big hammer and let out some frustrations. Make sure you turn the rotor a little each time you hit it.