0
How do you remove the airbag from the steering wheel on a 1996 suburban?
Wiki User
∙ 17y ago
You may want to bring this to a dealer....or if you feel ok with the disassembly, unhook your battery, and wait at least 10 minutes for the capacitor to discharge so the bag, or bags wont deploy...then from the rear of the steering wheel, remove the screws, and unhook the airbag..please remember, this can be dangerous, and caution is advised...with the utmost care...Johnny
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you remove the steering wheel off your 1994 mercury tracer?
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
How do you remove a steering wheel from a 1994 Mitsubishi 3000 gt?
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
How do you disarm the airbag on a 94 camaro and remove the steering wheel?
simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.
How do you remove the steering wheel on a 1996 Lincoln town car?
ok you have to check on your steering wheel in back of you steering wheel there will be a 2 or 4 bolts you gonna have to remove ,as soon your remove you steering wheel airbag you should see 2 wires one goes to airbag on other will be connected to you steering wheel switches ,,you should remove that and after that you gonna see one bolt you should remove it and you can after that you should be able to pull you steering wheel
How do you take the steering wheel off a Porsche 997?
you would need to disconnect the airbag then pop off the horn pad and remove the airbag then unbolt the steering wheel.
How do you remove steering wheel airbag on Corolla?
To remove an airbag from the steering wheel of a Corolla first make sure that the airbag system is disabled. Undo the two Tork screws on either side of the wheel. Once this is removed the connector for the airbag should be visible. Push the clip towards to horn pad and it should come out.
Can a 2000 Chevrolet S-10 Blazer steering wheel and airbag be replaced with an aftermarket steering wheel and no airbag?
No, it is illegal to remove the SRS from any vehicle you drive on public roads.
Where is turn signal switch on 98 explorer?
In the steering column. You'll have to remove the steering wheel with a steering wheel puller tool. This can be a dangerous repair job due to the airbag in the steering wheel. Get a Haynes or Chilton's manual for the details on how to do this as well as how to disarm the airbag system.
How do you remove steering wheel on 1995 suburban?
you need to buy a steering wheel. {Cheap at auto part store} remove your horn cover screws from behind the steering wheel. attach the pully, screw it in and it will pull the wheel off.
How do you remove a dodge stratus steering wheel with a airbag?
Have a mechanic do it. Air bags are nasty!
How do you remove 1999 holden commadore drivers airbag steering wheel?
To remove the driver's steering wheel airbag on a 1999 Holden Commodore you will need a special set of tools to remove the 4 to 6 security screws that are holding it in. If the vehicle came equipped with a airbag, it needs to have one to remain road safe.
How do I disable the driver side airbag on a 1995 Chevy Suburban so I can repair the horn switch in the steering wheel?
Airbag disableTurn the sterring wheel to the straight ahead position, place the ignition switch in lock, remove the key, then remove the airbag fuse from the fuse block. Remove the knee bolster and sound insulator panel below the instrument panel. Unplug the yellow connector position assurance (CPA) sterring column harness connector at the base of the steering column.
