Transmission Range Selector Lever Removal 1. Place transmission range selector lever in DRIVE. Remove console finish panel (04567). Refer to Section 01-12 . 2. Remove ignition/shifter interlock cable (3F719) and disconnect cable from range interlock cam. 3. Disconnect transmission range indicator lamp/transmission control switch electrical connector. 4. Raise vehicle on hoist. 5. Remove range cable retaining nut from transmission bracket. Disconnect shift cable and bracket (7E395) from transmission control selector connecting rod adjustment stud (7B415). 6. Lower vehicle. Remove transmission range selector lever and housing retaining bolts and remove transmission range selector lever. Installation 1. Install transmission range selector lever to front floor pan (11135) with retaining bolts. Tighten to 6-8 Nm (54-70 lb-in). 2. Connect shift cable and bracket. Tighten retaining screw to 3-4 Nm (27-35 lb-in). Install retaining clip and connect transmission range indicator lamp wire. 3. Install console finish panel. 4. Place the transmission range selector lever in DRIVE and apply a 1.4 kg (3 lb) rearward force to the lever. 5. Raise vehicle on hoist. 6. Connect shift cable and bracket to manual control lever (7A256) and transmission bracket. Make sure manual control lever is in DRIVE and tighten nut at bracket to 13-25 Nm (10-18 lb-ft). 7. Lower vehicle and check range selector for proper operation. Â Removal 1. Open console glove compartment door (06024) to access screws toconsole finish panel (04567). 2. Remove two screws and lift rear ofconsole finish panel to unsnap snap-in retainers. 3. Lift rear ofconsole finish panel and slide rearward to release two front locating tabs. Removeconsole finish panel.
How do you remove the automatic shifter cablein a 1997 GMC sierra 1500
On the front of the shifter handle there is a metal clip in which a flat head screwdriver can be inserted. Pry the clip out and the handle lifts off.
Automatic or manual trans?
there is a clip on the front of the shifter. pull this out and the outer part of the shifter will come off. next remove the center console. then you can get to the 4 bolts that hold the shifter in place.
remove it
Remove shift release button off the top of the shifter, inside there is a small snap ring. Remove the snap ring and lift the shifter knob off.
how do you remove the automatic transmission from the 2004 wrx.... i have everything disconnected except for the gearing fork shifter.
lightbulb in shifter is blown. remove shifter cover to replace bulb
Once you remove the dust cover attached to your shifter, you'll see your shaft going into a gear box. There will be a pin to remove and this will allow you to pull the shifter right out. good luck
I doubt very much that the knob will come off of the automatic column shifter.
Yes you can remove a manual transmission and replace it with an automatic. You will need to buy an aftermarket shifter kit of find a shifter for your vehicle from a junk yard. You will also either have to remove the clutch pedal or replace the pedal assembly
Yes, you can change the shifter handle. Remove the hairpin clip at the front side of the handle and lift the handle from the metal pipe.