Get one of those V-shaped interior door removers if you can or use any thing with an inch wide or so flat end that you can slip between the panel and the metal part of the door. If you have an old TABLE spoon that you can pound flat and then cut a V-shape notch in the center edge would work too. The panel has a series of "plugs" that plug into holes in the sheet metal. You have to try to separate the panel AT the "plug" areas so you have the best leverage. You have to carefully pry the plugs that the panel is popped into away from the door. The panel is just a fibre wood type so it doesn't take much to rip open the slots that the plugs are attached to. There's 20 or so pugs so slow and easy.
How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?
Clips hold the door panel in place. To remove the panel, you will need a small pry bar and apply gentle pressure to the gap between the panel and the inner part of the door.
You can replace the inside drivers door handle by removing the door panel. With the door panel removed the door handle mechanism will be visible. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Remove the screws in the door panel.
how do i remove the rear door panel of a 190 e?
The fuse box on a 1974 VW Beetle is located in the dash on the driver's side. The driver's side door must be open to access the fuse box which is located in a panel just to the left of where the driver's foot controls are.
how do i remove a door panel of a skoda octavis while door is stuck looked
Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.
remove the door panel on peugoet 407
how to remove the door panel on a 1992 mercury cougar
how do you remove the door panel on a 2001 dodge stratus?--2 door
To remove a door panel a person must use a screw driver, remove the screws and the clips that are holding the door panel to the door frame. Gently pull the panel away from the frame, remove any wire connectors and the panel will come off.