With an uncle and a hammer.
you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?
its on the tranny, drivers side lower porton of the bell housing
Right in front of the valve cover. You have to remove a cover to access it.
remove the starter for access to the t.c. nuts,i have done this twice
Under the drivers side foot area, at the top to the left of the clutch pedal.
2.0i 12v 6-8Nm 2.0i 16v 4-6Nm 2.2i 6-8Nm.
Should be 4 bolts one in each corner
take out bolts and lift, common sense really
just remove the 3 bolts on top of the valve cover and lift it out,and theres the gasket.
there's a panel to remove located in the front drivers side wheel well.
Try looking on the back of the fuse box cover, there is often a diagram there. If not it should be in the owner's manual.